Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
Connect an audio cable from the output o. the receiver to a mic/line input on your audio mixer or amplifier. Plug the receiver.s AC adaptor into the 12. input jack on the receiver, and then plug it into the 110-120 VAC electrical outlet. With the volume of you. mixer or amplifier set to minimum level, turn your system.s power on. Turn on the transmitter(s). Make sur. all LEDs on the receiver and transmitter(s) are operating as described in the preceding pages. Now set th. receiver.s volume to the midway point and adjust the volume level on your mixer or amplifier. 32BT, 31LT & 31XT: With someone talking into the microphone, turn the volume on the mixer or amplifie. to the desired level. If there is too much, or not enough gain, lower or raise the volume on the receiver. If th. sound is distorted, lower the input gain on the transmitter. 31HT: With someone talking or singing into the microphone, turn the volume control on the mixer or ampli. fier to the desired level. If there is too much, or too little gain, adjust the volume on the receiver. If the soun. is distorted, move the microphone further away from the sound source. 31IT: Plug the cable into a guitar or bass. Set the instrument volume to the midway point. While playing th. instrument, adjust the volume on the mixer or amplifier to the desired level. If there is too much, or too littl. gain, adjust the volume on the receiver. If the sound is distorted lover the input gain on the 31IT. With th. system now operating, move around the performing area to make sure no problems, such as feedback or R. signal loss occur. NOTES. - Do not use or store the system in areas of high temperature or humidity. - Do not use the system near a broadcast station, airport, or airplanes, as it may cause interference. If you ar. interfering with other transmissions, you must turn the system off. - These systems contain no user-serviceable parts. If any unauthorized service is performed, it may void th. warranty. FCC NOTES. AZDEN 32BT, 31HT, LT, IT, and XT, conform to Parts 74 & 90 of the FCC rules. The receivers conform t. part 15 of the FCC rules. You should contact the FCC office near you for the proper filing forms. SPECIFICATION. OVERAL. Frequency Range. VHF 169 -216MH. Working Range. Up to 300 fee. Distortion. Less than 1% (15kHz deviation. Frequency Response. 40Hz to 15kHz, 3d. Dynamic Range. Better than 100d. S/N Ratio. Better than 95d. Operating Temperature. 0° . 45° C (32° . 113° F. Noise Reduction. 2:1 logarithmic compressor/expande. Oscillator/Modulation. Crystal Controlled/F. Transmitte. 31H. 31L. 31I. 31X. Microphone Uni. Uni Dynami. Omni Electre. N/. N/. RF Output Powe. 10mW (50mW max. 30mW (50mW max. 10mW (50mW max. Input Impedanc. 8K ohm. 2.2K ohm. 100K ohm. 47K ohm. Audio Adj.Rang. N/. 30 d. Batter. AA (1.5V. 9V (006P. AA (1.5V. Battery Lif. 8-10 hours (using alkaline battery. Siz. 62X221m. 2.44X8.7. 86(H)X60(W)X21.5(D)m. 3.4(H)X2.3(W)X0.84(D). 86(H)X60(W)X21.5(D)m. 3.4(H)X2.3(W)X0.84(D). 33X120m...
Эта инструкция также подходит к моделям:Наушники и микрофоны - 31 HT (340.34 kb)
Наушники и микрофоны - 311DRH (340.34 kb)
Наушники и микрофоны - 32BT (340.34 kb)