Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
the same frequency. (8. Output (balanced. Using a suitable audio cable (not supplied) connect the XLR connector to the audio output on the receiver, an. connect the other end of the cable to the suitable mic/line input of an audio mixer or amplifier. 221R Two-channel VHF receiver. The 221R contains two VHF receivers operating on different frequencies. This allows single or simultaneou. use of two transmitters. The receiver features two 1/4-inch output jacks and two volume adjustments - one foreach channel. (1) Power/Receiving LED When the receiver is plugged in, both the A and B Power/Receiving LEDs will turn RED. When one or bot. of the transmitters is turned on and are within reception range of the receiver the A and/or B Power/Receivin. LEDs will turn from RED to GREEN indicating that the transmitter(s) signal is being received. (2) Antenna. Extend the antennas fully vertical for best reception. When not in use, lower the antennas and put them in thei. holders to avoid damage. (3) 12 Volt Inpu. Plug the supplied AC adaptor into the 12-volt input on the receiver then into a 110-120 VAC electrical outlet. Use only the adaptor supplied (BC-26U) as other adaptors may damage the receiver. (4) Output Adjustmen. Rotate this knob clockwise to increase, or counter-clockwise to decrease the volume level. Please note tha. the 221R has two output adjustments, one for Ch.A and one for Ch.. (5) Output (unbalanced. Using a suitable audio cable (not supplied), connect the 1/4-inch phone jack end of the audio output on th. receiver, and connect the other end of the cable to the mic/line input of an audio mixer or amplifier. Pleas. note that the 221R has two outputs, one for Ch.A and one for Ch.B. (6) Frequency labe. Indicates what frequencies (in MHz) the receiver operates on. The AZDEN transmitters in use must also b. on the same frequency. Please note that the 221R has two frequency labels, one for Ch.A and one for Ch.B. 211R Single channel VHF receiver. The 211R features a 1/4-inch output jack and volume adjustment. (1) Power/Receiving LE. When the receiver is plugged in, the Power/Receiving LED will turn RED. When the transmitter is turned o. and is in reception range of the receiver the Power/Receiving LED will turn from RED to GREEN indicatin. that the transmitter signal is being received. (2) Antenn. Extend the antenna fully vertical for the best reception. When not in use, lower the antenna and place it int. its. holder to avoid damage. (3) 12-Volt Inpu. Plug the supplied AC adaptor into the 12-volt input on the receiver and then into a 110-120 VAC electrica. outlet. Use only the adaptor supplied (BC-26U) as other adaptors may damage the receiver. (4) Output Adjustmen. Rotate this knob clockwise to increase, or counter-clockwise to decrease volume level. (5) Output (unbalanced. Using a suitable audio cable (not supplied) connect a 1/4-inch phone jack end to the audio output on th. receiver and connect the other end of the cable to the mic/line input of...
Эта инструкция также подходит к моделям:Наушники и микрофоны - 31 HT (340.34 kb)
Наушники и микрофоны - 32BT (340.34 kb)
Наушники и микрофоны - 221R (340.34 kb)