Оценок - 5, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
REFER TO PRODUCT DATA PLATE(S) FOR ADDITIONAL OPERATING INSTRUCTIONS AND SPECIFICATIONS. CAUTION • Keep work area clean, well-lit and uncluttered. • Keep safety labels clean and in good condition. • Replace missing or damaged safety labels. • Wear safety glasses while installing or performing maintenance on pump. • Adhere to the guidelines of the National Electric Code (NEC) or Canadian Electric Code (CEC), and any other state and local codes for ALL electrical installations. Check with the appropriate agencies or contact a licensed electrician. Most water system problems result from improper installation. It is suggested that you read this manual carefully before installing your pump. The “TROUBLESHOOTING SECTION” will assist you in locating and eliminating the cause of any trouble you may encounter after installation. Check and make available all the tools you will need to install your pump. Required tools may include wrenches, pipe sealant, pipe fittings and nipples, screwdriver, etc. Be sure to have available proper and adequate wiring material to complete the installation correctly. READ AND FOLLOW SAFETY INSTRUCTIONS This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the following signal words and be alert to the potential for personal injury: DANGER warns about hazards that will cause serious personal injury, death or major property damage if ignored. WARNING warns about hazards that can cause serious personal injury, death or major property damage if ignored. CAUTION warns about hazards that will or can cause minor personal injury or major property damage if ignored. NOTICE indicates special instructions, which are important but not related to hazards. Carefully read and follow all safety instructions in this manual and on pump. WA RNING WARNING WARNING HAZARDOUS PRESSURE: Do not run pump against closed discharge. Release all system pressure before working on any component. CAUTION Do not run pump dry. Fill pump with water before starting or pump will be damaged. The motor on this pump is guaranteed by the manufacturer and in event of failure it must be returned to an authorized service station for repairs. Motor warranty is void if repairs aren’t made by an authorized repair station. ELECTRICAL SAFETY CAUTION Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. WARNING Capacitor voltage may be hazardous. To discharge motor capacitor, hold insulated handle screwdriver BY THE HANDLE and short capacitor terminals together. Do not touch metal screwdriver blade or capacitor terminals or electrical shock could occur. If in doubt, consult a qualified electrician. WARNING Wire motor for correct voltage. See “Electrical Installation” section of this manual and motor nameplate. Ground motor before connecting to power supply. Hazardous voltage. Can shock, burn, or Meet National Electrical cause death. Code (NEC) or Canadian Electrical Code(CEC) and Ground pump before local codes for all wiring. connecting to power supply. Disconnect Follow all pump wiring power before working instructions provided in on pump, motor this manual. or tank. CAUTION DO NOT touch an operating motor. The surface of the motor may be HOT. Allow the motor to cool for thirty (30) minutes before handling. GENERAL SAFETY • Do not allow pump or any system component to freeze. To do so will void the warranty. • This pump has been evaluated for pumping water only. Pumping liquids other than water may void warranty. • Periodically inspect pump and system components. INTRODUCTION You have purchased one of the most user friendly pumps available. The Turf Boss pumps are made with high quality materials which are designed to provide you with years of reliable service. Lawn sprinklers are designed to maximize output flow, while still maintaining the ability to draw water from a source up to 25 feet below the pump. All mechanical parts, motor, impeller, electrical controls, etc., are above ground within easy reach. If service is ever necessary, simple hand tools will do the job. This lawn sprinkler pump installs easily and quickly without the need for special tools or pump rigs. You can install it yourself provided you follow closely the instructions contained in this manual. INSPECT YOUR SHIPMENT All Turf Boss lawn sprinkler pumps are carefully tested, inspected, and packaged to insure their arrival in perfect condition. When the pump is received, examine it closely to make sure there is no damage or broken parts that may have occurred in shipping. If damage is evident, report this immediately to your shipping carrier and dealer. This shipping carrier assumes full responsibility for the shipment’s safe arrival. Any claim for damage to the shipment, either visible or concealed, must be made through the shipping carrier first. PRE-INSTALLATION CHECK • Pump must not be more than 25 feet above the surface of the water. • Use as few elbows and fittings as possible to reduce...
Эта инструкция также подходит к моделям:Насосное оборудование - TB1CI (1.52 mb)
Насосное оборудование - TB2CI (1.52 mb)