Оценок - 1, средний балл: 4
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Place the entire assembly onto the hi-hat upper pull rod and tighten the wing bolt to secure the desired position of the top cymbal. The lock nuts on the top of the clutch can adjust the feel and sound of the hi-hat cymbals. To obtain a loose sound, open the nuts off of the felt; for a tight sound, close the nuts onto the felt. Once the desired sound has been obtained, tighten firmly the lock nuts onto each other. e Position Clamp (HS850,HS740A only) Once the bottom hi-hat cymbal height has been decided, the position clamp can be used to mark the settings for future setups and to prevent unintentional changes during musical performances. Use a drum key to firmly tighten the position clamp into place. r Spring Tension Knob (HS850,HS740A only) The Spring Tension Knob supplies tension control over an 11-step range. To increase tension, slide the Spring Tension Knob up (Fig. A) to any position you like (use the scale as a reference) and then rotate the knob to the left to lock in place (Fig. B). To reduce tension, rotate the Spring Tension Knob to the right (Fig. C) and slide to any position you like. To increase tension, slide the Spring Tension Knob up, to decrease tension, slide the Spring Tension Knob down. t Footboard Stabilizer Rod The Footboard stabilizer rod should attach to holes in the frame at the bottom of the hi-hat base. y Spur The large heavy-duty rubber feet prevent unwanted movement of the hi-hat stand during playing conditions. To minimize slippage further, there are two spurs in the frame. These spurs can be extended as needed by adjusting the turn screws provided on either side of the frame base. u Leg Position Adjustment (HS850,HS740A only) Loosen Bolts A and B (Fig.D) to change the position of the legs (footboard). After the position has been determined, tighten both Bolts A and B firmly. Also, we recommend that the legs be positioned in the same manner as shown in the illustration on the left so as to leave some space available for setup and to provide sufficient stability for the stand. (This setup is for right-handed drummers. For left-handed drummers, please set up in an opposite manner.) * This product photograph is HS740A. FootBoard Leg Leg Leg To maintain smooth action, occasionally apply some greasegrade oil to all of the moving parts. Be careful not to use excessive force when tightening the extender base nut as this may damage the nylon bushing inside the tube. . Spring Tension Adjustment (Fig.A) (Fig.B) (Fig.C) Spring Tension Knob . Cymbal Support Plate . Hi-Hat Clutch Wing Bolt Lock Nut Felts Clutch Bolt Clutch Nut Lock Nut Knob Bolt Felt Fiber Cymbal Support Plate (Fig.D) q ....... ............................ ............................ ............................. ................... ............................ ........ w ......... .............................. ............................... .................................
Эта инструкция также подходит к моделям:Музыкальные инструменты - HS650A (2.23 mb)