Оценок - 4, средний балл: 4.3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
2. Apply some soap water solution to the brush on the end of flexible cleaner and use the cleaner to clean the inside of the instrument’s tubing. 3. After cleaning the instrument, use clean water to thoroughly rinse out the dirt and soap. 4. After completely removing all moisture with a gauze, apply oil and grease. Take Care When Cleaning Inside of the Instrument Never dismantle the rotors. Also, when rinsing the tubing with water, run water through the main tuning slides in the opposite direction of the airflow. If water is run through the instrument from the mouthpiece, dirt can become clogged in the valves causing the valves to become sluggish. 5. Apply some soap water solution to a mouthpiece brush and insert it into the throat to clean the mouthpiece, then thoroughly rinse it out with clean water. 28 Tying the Rotor Strings . Wind the string as shown in the illustration below, and tighten the string stopper screw. Wind the string around the screw in the same direction that the screw tightens. After winding, use the String Stopper Screw B to adjust the lever’s height. Rotor Stem Screw String Stopper Screw B String Stopper Screw A Lever Linkage Lowers the lever Raises the lever The YHR-567/567D is used in this illustration. ¦ Switching the 4th Lever Function . F/Bb Double Horn The Yamaha double horn is designed so that it normally plays in the key of F (open F) when the 4th lever is not depressed, and in the key of Bb when the 4th lever is depressed. However, by re-configuring the linkage as shown in the illustration below, this function can be reversed so that the horn plays in Bb (open Bb) when the lever is not depressed, and in the key of F when the lever is depressed. To use this setup, move the string and the string seat, then place the string over the string seat. String Stopper Screw B Rotor Stem Screw Lever Linkage String Stopper Screw A Open F Open Bb The YHR-567/567D is used in the illustration. 29 Other Adjustments You can change the stroke from long to short by changing the position of the bearing stopper screw on the YHR-567GDB. (Open F is shown in the illustration.) The 4th lever on the YHR-667V/VS, YHR-668D/ND, YHR-567/567GDB can be adjusted to better fit the players hand size and position. Use a screw driver and adjust the lever length as shown in the illustration below. Bearing stopper screw Install here for Open Bb. * When the bearing stopper screw is installed near the rotating center, the stroke will become short. When the screw is installed far from the rotating center, the stroke will become long. 30 Options . Eb Crook (optional) This optional main tuning slide is designed for the YHR-314 and transforms the single F horn into an Eb horn so that you can play Eb parts without transposing. The crook is designed so that the horn fits in the case when it is attached. Main Tuning Slide Eb Crook When using the Eb crook, the 1st through 3rd valve tuning slides should be pulled out a little. 31 Options . F Natural Slide (optional)...
Эта инструкция также подходит к моделям:Музыкальные инструменты - YHR-882 (6.76 mb)
Музыкальные инструменты - YHR-891 (6.76 mb)
Музыкальные инструменты - YHR-891D (6.76 mb)
Музыкальные инструменты - YHR-892 (6.76 mb)