Оценок - 4, средний балл: 3.8
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
They are: • Standard Mode—This mode is for sending both Control Change messages and Program Change messages. • Control Change Mode—This mode is for sending only Control Change messages. • System Exclusive Mode—This mode is for sending or receiving System Exclusive messages. • Patch Mode—This mode is for sending multiple MIDI messages that have been previously been saved as patches. Here's how to choose the desired mode: 1 Press the MODE button repeatedly until the mode you want is selected. Tip: To select modes with your feet, simultaneously press the up and down ▼ pedals. Changing the Control Change Numbers Assigned to the Pedals You can assign any Control Change number (CC#) to a pedal. Here's how: 1 Press MODE until the red indicator is lit next to CONTROL. 2 Press the PARAMETER ► button once-“PDL1 :Assign CC#65” appears in the display. 3 Press VALUE or ▼ to change the CC it number. If you’d like to change the CC it values for the other pedals, repeat Steps 2 and 3. 4 Once you’ve made all of your desired CC it assignments, press WRITE. 5 Press or ▼ to select a memory location (1-5) in which to store your new setup. 6 Press WRITE twice—the new settings are now stored into the FC-300's memory. ©2007 Roland Corporation U.S. FOOT CONTROLLER TurboStart If you'd like to redo the FC-300's settings from scratch, you can use the following procedure to clear its internal memory and reload its factory settings. Caution: All of your stored settings will be lost when you perform a factory reset. Be sure to back up any information you wish to keep first. 1 Turn off the FC-300. 2 While holding down and ▼, turn on the power—"Factory Reset Are you sure?" appears in the display. 3 Press WRITE. 4 When "Factory Reset Completed!" appears, turn off the FC-300. 5 Power-up the ...