Оценок - 1, средний балл: 3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Switching this on allows you to produce a sound that preserves the same tone and balance at an output of 2 watts, for volume levels that are more suitable for the average home. * The Power Squeezer function affects only sounds input through the INPUT jack. It has no effect on sounds input via the AUX IN jack. 14. AUX IN Jack You can connect a CD player, digital audio player or other kind of device and have it play along with your guitar. This accepts a stereo miniature phone plug. However, the speaker and RECORDING OUT/PHONES output is monaural. Use a cable (sold separately) that’s appropriate for the device you’re connecting. * Determine the volume level by adjusting the volume control of the connected device. * When connection cables with resistors are used, the volume level of equipment connected to the AUX IN jack may be low. If this happens, use connection cables that do not contain resistors. 15. FOOT SW (Foot switch) Jack You can use foot switches (optional BOSS FS-5U or FS-6) to switch channels (JC CLEAN/LEAD), and to turn EFX/SOLO on and off. * CUBE-20XL is equipped with a TRS-type FOOT SW jack that accepts plugs of the configuration shown in the figure. To connect a foot switch pedal, use a TRS-compatible cable. TIP : SELECT RING : EFX/SOLO * For details on connecting foot switches, refer to “Connections” (p. 6). * If you use a monaural cable to connect only one foot switch, it can be used to switch channels (JC CLEAN/LEAD). 16. RECORDING OUT/PHONES Jack • When Using RECORDING OUT Use mono 1/4” phone plugs when connecting to this jack. Volume level of RECORDING OUT can be easily adjusted if you set the JC CLEAN or LEAD Channel [VOLUME] knob as shown in the diagram on the right. • When Using Headphones Connect headphones to this jack. * No sound is played through the unit’s speaker while the RECORDING OUT/PHONES jack is in use. 17. [POWER] Switch This switches the power on and off. Connections Switching the Power On and Off Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all [VOLUME] knobs on the CUBE-20XL and all the connected devices are set to 0. 2. Turn on all the devices connected to the CUBE-20XL’s input jacks (INPUT jack and AUX IN jack). 3. Turn on the CUBE-20XL. * Always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a malfunction. * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally. 4. Adjust the volume levels for the devices. 5. Before switching off the power, lower the volume on each of the devices in your system and t...
Эта инструкция также подходит к моделям:Музыкальные инструменты - CUBE 20XL (15.76 mb)