Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
* Noise may be produced if wireless communications devices, such as cell phones, are operated in the vicinity of this unit. Such noise could occur when receiving or initiating a call, or while conversing. Should you experience such problems, you should relocate such wireless devices so they are at a greater distance from this unit, or switch them off. * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. * If there are batteries in the unit while an AC adaptor is being used, normal operation will continue should the line voltage be interrupted (power blackout or power cord disconnection). * Once the connections have been completed (p. 8), turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. When powering up: Turn on the power to your guitar amp last. When powering down: Turn off the power to your guitar amp first. * Always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a malfunction. * When operating on battery power only, the unit’s indicator will become dim when battery power gets too low. Replace the battery as soon as possible. Operating the Unit 564 3 2 1. When you have made the necessary connections (p. 8), depress the pedal switch to turn the effect on. (the CHECK indicator turns red.) * When MOMENTARY mode is selected, continue pressing the pedal switch. (the effect is on only while the pedal is depressed) 2. Select the mode with the MODE knob. * When MOMENTARY is selected, the CHECK indicator light goes off, and the effect is switched off. Hold the pedal down when using the following settings in MOMENTARY mode (the effect is on only while the pedal is depressed). 3. Set the flanging rate with the RATE knob. 4. Set the sweep depth with the DEPTH knob. 5. Set the center frequency to which the effect is applied with the MANUAL knob. 6. Turn the RES knob to set the strength of the effect. Setting the RATE by Inputting the Tempo with the Pedal Switch When Switching to Tempo Input with the Effect ON (CHECK indicator: Red) * RATE cycles for use with the tempo settings can be made in the range of 0.1–18 seconds. CHECK Indicator Red On Off Off 1 Press and hold the BF-3’s pedal switchfor at least two seconds. Red/Green Blinking On 2 Press the BF-3’s pedal switch in timing with the tempo. Red Off 3 Press and hold the BF-3’s pedal switchfor at least two seconds. Flanger Effects Pedal Switch RATE Effect reflects knob positions Effect synchronized to tempo * If you carry out Step 3 immediately after Step 2 , Step 3 may inadvertently be interpreted as tempo input, thus changing the RATE setting. Allow a brief interval to pass before progressing...
Эта инструкция также подходит к моделям:Музыкальные инструменты - BF-3 (662.27 kb)