Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Demagnetize them (see page 37). There is excessive wow or flutter, or the sound drops out. • The capstans or pinch rollers are dirty. Clean them (see page 37). Noise increases or the high frequencies are missing. • The record/playback heads are magnetized. Demagnetize them (see page 37). Tuner Severe hum or noise (“TUNED” or “STEREO” flashes in the display. • Adjust the antenna. • The signal strength is too weak. Connect an external antenna. A stereo FM program cannot be received in stereo. • Press STEREO/MONO so “STEREO” appears in the display. If other problems not described above occur, reset the system as follows: (LBT-D290/D590/G3300/XB3/XB3K/KB4/ XB4K only) 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press SPECTRUM ANALYZER, ENTER/ NEXT, and DISC 1 at the same time. (LBT-D690/XB600/XB6/XB6K only) 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press GROOVE, ENTER/NEXT, and DISC 1 at the same time. Specifications For the U.S. model AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 8 ohm loads, both channels driven, from 70 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.9% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Continuous RMS power output (LBT-D290/D590/D690/G3300) Canadian model: 100 + 100 watts (8 ohms at 1 kHz, 5%) (LBT-XB3/XB3K) 70 + 70 watts (6 ohms at 1 kHz, 10% THD) (LBT-XB4/XB4K) 80 + 80 watts (5 ohms at 1 kHz, 10% THD) (LBT-XB600/XB6/XB6K) 100 + 100 watts (8 ohms at 1 kHz, 10% THD) Peak music power output (LBT-XB3/XB3K) 1000 watts (LBT-XB4/XB4K) 1200 watts (LBT-XB600/XB6/XB6K) 1400 watts Inputs PHONO IN (phono jacks): sensitivity 3 mV, impedance 47 kilohms VIDEO (AUDIO) IN (phono jacks): sensitivity 250 mV, impedance 47 kilohms MIX MIC (phone jack): sensitivity 1 mV, impedance 10 kilohms Outputs PHONES (stereo phone jack): accepts headphones of 8 ohms or more SPEAKER: (LBT-D290/D590/D690/G3300/XB600/XB6/XB6K) accepts impedance of 8 to 16 ohms. (LBT-XB3/XB3K) accepts impedance of 6 to 16 ohms. (LBT-XB4/XB4K) accepts impedance of 5 to 16 ohms. SURROUND SPEAKER (LBT-D590/D690/XB600/XB6/XB6K only) accepts impedance of 16 ohms CD player section System Compact disc and digital audio system Laser Semiconductor laser (l = 780 nm) Emission duration: continuous Laser output Max. 44.6 mF* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. Wavelength 780 – 790 nm Frequency response 2 Hz – 20 kHz (±0.5 dB) Signal-to-noise ratio More than 90 dB Dynamic range More than 90 dB Tape player section Recording system 4-track 2-channel stereo Frequency response (DOLBY NR OFF) 60 – 13,000 Hz ( ±3 dB), using a Sony TYPE I cassette 60 – 14,000 Hz ( ±3 dB), using a Sony TYPE II cassette Wow and flutter ±0.15% W. Peak (IEC) 0.1% W. RMS (NAB) ±0.2% W. Peak (DIN) Tuner section FM stereo, FM/AM superheterodyne tuner FM tuner section Tuning range North American model: 87.5 – 108.0 MHz (100 kHz step) Other models: 87.5 – 108.0 MHz (50 kHz step) Antenna FM wire antenna Antenna terminals 75 ohm unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range North American model: 530 – 1,710 kHz (with the tuning interval set at 10 kHz) 531 – 1,710 kHz (with the tuning interval set at 9 kHz) Other models: 531 – 1,602 kHz (with the tuning interval set at 9 kHz) 530 – 1,710 kHz (with the tuning interval set at 10 kHz) Antenna AM loop antenna, External antenna terminals Intermediate frequency 450 kHz Speakers General SS-D2900/XB3/XB3V for LBT-D290/G3300/XB3/ Power requirements XB3K North American model: 120 V AC , 60 Hz Speaker system Mexican model: 120 V AC , 50/60 Hz (SS-D2900/XB3) 3-way, 3-unit, bass-reflex Malaysian and Australian models: type (SS-XB3V) 3-way, 3-unit, bass-reflex, Magnetically shielded type Speaker units Woofer: 17 cm dia., cone type Tweeter: 6 cm dia., cone type Super Tweeter: 2 cm dia., dome type Nominal impedance: (SS-D2900) 8 ohms (SS-XB3/XB3V) 6 ohms Dimensions (w/h/d) Approx. 235 . 480 . 295 mm (9 3/8 . 19 . 11 5/8 in) Mass (SS-D2900/XB3) Approx. 6.0 kg (2 lb 12 oz.) net per speaker (SS-XB3V) Approx. 6.2 kg (2 lb 13 oz.) net per speaker SS-D5900V/XB4V/XB6000V for LBT-D590/XB4/ XB4K/XB600 Speaker system 3-way, 3-unit, SAW, Magnetically shielded type Speaker units Super Woofer: 17 cm dia., cone type Woofer: 17 cm dia., cone type Tweeter: 6 cm dia., cone type Nominal impedance: (SS-D5900V/XB6000V) 8 ohms (SS-XB4V) 5 ohms Dimensions (w/h/d) Approx. 260 . 525 . 415 mm (10 1/4 . 20 3/4 . 16 3/8 in) Mass Approx. 13.0 kg (5 lb 14 oz.) net per speaker SS-D6900V/XB8V for LBT-D690/XB6/XB6K Speaker system 4-way, 4-unit, SAW, Magnetically shielded type Speaker units Super Woofer: 17 cm dia., cone type Woofer: 17 cm dia., cone type Tweeter: 6 cm dia., cone type Super Tweeter: 2 cm dia., dome type Nominal impedance: (SS-D6900V/XB8V) 8 ohms Dimensions (w/h/d) Approx. 285 . 590 . 450 mm (11 1/4 . 23 1/4...
Эта инструкция также подходит к моделям:Музыкальные центры - LBT-XB3 (703.33 kb)
Музыкальные центры - LBT-XB6 (703.33 kb)
Музыкальные центры - LBT-XB6K (703.33 kb)