Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Connecting the stand 1. Place the monitor with its front facing downward on a soft cloth. 2. Assemble the stand Body into the product in the correct direction as shown in the picture. Make sure you push it until you hear it “click”. 3. Assemble the Stand Base(Front, Rear) into the Stand Body in the correct direction. Stand Body Hinge Body Stand Body Stand Base 4. Use a coin on the back of the stand base and turn the screw clockwise to tighten. 5. Once assembled take the monitor up carefully and face the front side. Important (Text) This illustration depicts the general model of connection. Your monitor may differ from the items shown in the picture. Do not carry the product upside down holding only the stand base. The product may fall and get damaged or injure your foot. 5 Connecting the Display Disassembling the stand 1. Put a cushion or soft cloth on aflat 2. Place the monitor face Down on the surface. cushion or soft cloth. 3. Remove the Stand Body and Stand 4. Use a coin on the back of the Stand Base from product in correct Base and turn the screw anticlockdirection as shown in the picture. wise to loosen. 6 Connecting the Display Before setting up the monitor, ensure that the power to the monitor, the computer system, and other attached devices is turned off. Positioning your display -After installation, adjust the angle as shown below. 1. Adjust the position of the panel in various ways for maximum comfort. Tilt Range : -5. to 15. ERGONOMIC It is recommended that in order to maintain an ergonomic and comfortable viewing position, Do not touch or press the screen whenadjusting the angle of the monitor. When adjusting the angle of the screen, donot put your finger(s) in between the head of the monitor and the stand body. You can hurt your finger(s). the forward tilt angle of the monitor should not exceed 5 degrees. 7 Connecting the Display E1941T/E2041T/E2241T/E2341T/E2441T Connecting the Display E1941T/E2041T/E2241T/E2341T/E2441T Connecting with the PC 1. Before setting up the monitor, ensure that the power to the monitor, the computer system, and other attached devices is turned off. 1 2. Connect signal input cable and power cord 2 in order, then tighten the screw of the signal cable. Connect DVI-D(Digital signal) Cable Connect D-sub(Analog signal) Cable A B NOTE This is a simplified representation of the rear view. This rear view represents a general model; your display may differ from the view as shown. PCPCABWall-outlet type Mac adapter : For Apple Macintosh use, a separate plug adapter is needed to change the15 pin high density (3 row) D-sub VGAconnector on the supplied cable to a 15 pin 2 row connector. When using a D-Sub signal input cable connectorfor Macintosh Varies according to model. Connect the signalinput cable and tightenit up by turning in thedirection of the arrow as shown in the figure. 3. Press the power button on the front panel to turn the power on. When monitor power is turned on, the 'Self Image Setting Function' is ex...
Эта инструкция также подходит к моделям:Мониторы - E1941S-BN (4.88 mb)
Мониторы - E1941T-BN (4.88 mb)
Мониторы - E2041S (4.88 mb)
Мониторы - E2041S-BN (4.88 mb)