Оценок - 1, средний балл: 4 ( )

Производитель: Electrolux Размер: 894.87 kb Название файла: Язык инструкции:

The PASSWORD allows the following functions to be locked in order to limit oven use (one or more by request): - Disables the temporary modification of automatic programmes, including the special PreHeat, Low Temperature cycles and Recipes. - Manual cooking cycles are made unusable. - Prevents final modification, saving or cancellation of the automatic programmes. Once the PASSWORD is enabled, the oven is locked (after switching on) against the use of the above functions; a password must be entered to unlock it. To enter a password: 1) press button P and select the item PASSWORD, press P again, and the display shows: _******* factory-set oven password (8 characters formed of 8 empty spaces) 2) Press P (oven unlocked) and select CHANGE PASSWORD with the arrow button “v” (down). 3) Press P, the item New PASSWORD appears, enter the password (alphanumeric 8 characters or less) like entering the name of a recipe (see par. 4.4.4 STORING RECIPES or PROGRAMMES). 4) Press P, the item CONFIRM PASSWORD requests confirmation of the password entered by typing it again, then press P. After a short beep signalling successful operation, or a long beep if failed, the oven goes to the initial switching on status and is thus unlocked. To lock it again, just switch it off. To change a password repeat the previous operations from point 2). To quit the menu, if the PASSWORD is not known, switch the oven off and then on again. 5. INFORMATION AND ERROR CODES These codes may appear on the time display. INFORMATION codes Codes indicating a value, function, or state. Cln - CLEANING SYSTEM program switched on. Clnt - Semiautomatic cleaning program switched on. cont - Unlimited time setting. cool - Oven cooling on. 27 USA 5938 035 01 End - End of a cycle or function. FILL - Boiler filling. (Ensure water supply tap/cock are open). Hold - Cooking option, HOLD function active. LOAd - Place the food in the oven. oPEn - Boiler discharge valve opening. PrEH - (TIME TM / PRB DISPLAY)Boiler preheating. PrEH -(COMPARTMENT TEMP. DISPLAY TS) Automatic compartment preheating. Soap - Detergent. Spray a suitable product on the surfaces to be cleaned as indicated in point 4) of the semiautomatic chamber cleaning cycle (see par. 7. CARE AND MAINTENANCE). StArt - Press the START button to start the program. Stby - CLEANING SYSTEM cleaning standby time. ERROR codes Codes indicating the need to call technical service EH2O - Water supply pressure too low for CLEANING SYSTEM (pressure requirements from 1.5 to 2.5 bar) EFUN - Fan automatic reset thermal switch device. UP appears on the small DISPLAY with reference to the single fan (6-10 GN) or upper fan (20 GN) of the chamber and DO in reference to the lower fan (only 20 GN). E—- - Non-compliance with a parameter requirement (number of parameter appears in place of dashes “—”). EPt1 - Chamber sensor interrupted or short-circuited. EPt2 - Boiler sensor interrupted or short-circuited. EPt3 - Probe sensor interrupted or short-circuited. EPt4 - Bypass sensor interrupted or short-circuited. EPt8 - Electronic controller temperature sensor damaged. ESCH - Malfunction of commands control circuit cooling devices. Etub - Boiler overtemperature (257°F)(125°C) warning. Etuc - Chamber overtemperature (608°F)(320°C) warning. EFLP - Fault in chamber steam discharge motor-operated valve. ETC - Tripping of chamber temperature limiter. ETB - Tripping of boiler temperature limiter. IMPORTANT! If an error code is displa...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: