Оценок - 2, средний балл: 3.5 ( )

Производитель: Electrolux Размер: 894.87 kb Название файла: Язык инструкции:

of pure vinegar. 5) Open the water cock. 6) Run a “steam” cycle for 20 minutes. 7) Switch off the oven and wait 60 minutes. 8) Restart the oven in steam mode for a further 10 minutes. 9) Switch off the oven again and wait 60 minutes. 10) With the water cock open, re-open the drain outlet and drain off the vinegar (press the above button). 11) Switch off the oven. 12) Insert a rubber hose inside the boiler filler pipe and rinse thoroughly until the water flowing out of the drain is clear. 13) Refit the filler plug and close the boiler drain (press the above button). 7.1.3 DESCALER CLEANING METHOD If you decide to descale the boiler using a chemical product, follow the directions provided by the product supplier. For example, when using ECOLAB's “STRIP-A-WAY” descaler, proceed as follows: • Follow the instructions given in the previous paragraph and supply the following product quantities via the boiler filler pipe: - 2 litres of descaler liquid plus 6 litres of water (6-10gn). - 4.5 litres of descaler liquid plus 11.5 litres of water (20gn). • Run a “steam” cycle for 12 minutes. • Switch off the oven and wait 40 minutes. • Reopen the boiler drain outlet and proceed as described in the paragraph above. 29 USA 5938 035 01 IMPORTANT - 1 Insert a rubber hose inside the boiler filler pipe and rinse thoroughly with water to remove all traces of descaling agent. • Refit the filler plug and close the boiler drain (by pressing the relative button). After descaling the boiler, it is good practice to execute a 30- minute STEAM cycle with the oven empty. IMPORTANT - 2 If the water supply cock cannot be easily accessed, to empty the boiler proceed as follows: 1) Open the boiler discharge valve with the special pushbutton. 2) Wait 2 minutes and switch the oven off; the discharge valve will close automatically. 7.2 REPLACING CONSUMABLE COMPONENTS Changing the oven chamber lamp (Fig. 3) If the oven chamber lamp burns out, replace as follows: • Disconnect the appliance from the power supply. • Unscrew the four screws fixing flange "A" and remove glass shield "V" together with seal "G". • Remove halogen lamp "L" and fit an equivalent lamp with identical characteristics (12V - 20W - 572°F). Important: do not touch the new lamp with your fingers, wrap it in paper or a clean cloth when fitting. • Refit the glass shield with the seal in the lamp recess then smear food grade silicone grease on the seal and secure the flange using the four screws. 3 Replacing the oven door seal (Fig. 4) N.B.: The oven door seal is prone to normal wear and aging and should be replaced whenever it starts to harden or crack. To change the oven door seal proceed as follows: • prise the seal out of its seat and remove all traces of old silicone from the channel. • apply a bead of silicone sealant in point 1 along the internal frame of the seal seating channel. • insert the new seal, pressing it home along the entire length of the channel. 4 7.3 SPECIAL CLEANING INSTRUCTIONS Cleaning and checking the drain system Periodically clean the drain pipe and check for obstructions that may prevent the water from draining. Cleaning the oven door glazing panels (Fig. 5) Only clean the panels when the glass is cool and never use abrasive cloths or detergents. To access the double glazing cavity, open the internal panel, which is hinged to the door. • Open the oven door and press both upper and lower clips F to release the internal glazing panel. 5 After clea...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: