Full discharge will be indecated by the ‘8ATTA.OW indicator. • The above will prevent the batteries from developing •memory' which effectively reduces their capacity. • It is better to store Ni-Cd batteries that are discharged rather than charged. • Never use batteries which differ from the ones recommended. Do not mix old and new batteries or batteries of different capacities. • If you experience problems when using the transceiver, check the following: A. Batteries must be in good conditi

Proper operation of this radio under normal conditions results in user exposure to RF energy below the Occupational Safety and Health Act and Federal Communication Commission limits. Mandatory Safety Instructions to Installers and Users: This radio is NOT approved for use by the general population in an uncontrolled environment. This radio is restricted to occupational use and work related operations only. Radio operators must have the knowledge to control their exposure conditions and the expos

SO-239 antenna connector. 2. 13.6 V DC power connector (negative ground only). 3. 3.5 mm mono audio jack for external speaker connection. 4. High density DB15 option interface connector. Backlit LCD Details Transmit Low transmit Open audio Scan Talk-around Scan list indicator power path indicator indicator indicator Receive signal High transmit Scan priority Off-hook Key lock strength power channel scan stop indicator © 2007, Midland Radio Corporation Olympian™ Series Mobile Radio User’s Guide S

Use the and keys to select the desired bank. Press the A key to enable (e) or disable (D) the bank for scan. Press the and keys to select another bank or press B D C or to exit. Channel Scan Edit To add or remove a channel in the current bank from the scan list, press and hold the Scan programmable button for two seconds. Use the and keys to select the desired channel. Press the A key to enable (e) or disable (D) the channel in the scan list. Press the and C keys to D select another channel or p

Midland Radio Corporation subscribes to the same safety standard for the use of its products. Proper operation of this radio will result in user exposure far below the Occupational Safety and Health Act (OSHA) and FCC limits. ? DO NOT transmit for more than 50% of total use time (50% duty cycle). Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded. ? This radio is NOT approved for use by the general population in an uncontrolled environment. Th

If you press the upper function button for less than two seconds the monitor mode will be activated while pressed and deactivated when released. For details, please see the “Monitoring the channel” section. .. If you press the upper function button for more than two seconds the monitor mode will latch on. To turn the monitor mode off, press and release the upper function button. For details, please see the “Monitoring the channel” section. [8] PTT (Push to talk) button. The PTT button must be pr

The LED indicator will glow red indicating the battery is charging. 5. The rapid charger will fully charge the 1300 mAH NiMH battery in approximately 1.5 hours. The rapid charger will change to a green LED and switch to a trickle charge rate when a full charge is detected. The standard rate charger will charge at a constant rate (requires about 12 hours to fully charge a dead battery) and batteries should not be left in the charger longer than 15 hours. The LED of the standard rate charger does

.. If the status LED blinks red once every five seconds in standby, the battery needs charging. When a low battery condition is detected, the radio will automatically revert to low power when transmitting to help prolong the battery's life. If beeps are enabled, two short beeps will be heard before each transmission indicating the radio has automatically switched to low power mode. Sending a 2-tone/selective call or emergency call Your radio may have been programmed to send a 2-tone or selective

In this book… IN THIS BOOK…................................................................................................................................................. 2 WARNING NOTES ................................................................................................................................................. 3 FCC LICENSING INFORMATION............................................................................................................................ 3 SAFETY ....