Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Choosing the best location for your phone. When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. CHARGE the new phone for 20 -25 hrs. AVOID MoistureAVOID 3 multi power boards. AVOID connecting more than overload the power outlet. CHOOSE a location next to your bed AVOID Television sets and other electronic appliances Microwave ovens AVOID Moisture AVOID Computers other cordless phones Note: Ringing will not be impaired by adding extra cordless handsets. phones as ringing may be impaired AVOID AVOID DON’T Page i Installing the Base Unit Page ii INSTALLATION Plug the telephone cord into the Base Unit, then into the telephone socket on the wall. Plug the AC Adaptor cord into the Base Unit, then the AC Adaptor into the wall power point. Press the AC Adaptor cord into the curved recess under the Base Unit. Radio Antennae: The AM antenna is built into the main base. The FM antenna is the thin wire located at the rear of the main base. Unwind the antenna wire, keep straight and extended for radio use. Installing the Charge Cradle (XSR918 only) Plug the AC Adaptor cord into the Charge Cradle, then the AC Adaptor into the wall power point. AC adaptor New Zealand Australia Tel Line Adaptor (Not supplied) Power Point Main Base Power Point Installing the Handset Battery INSTALLATION • Press the battery cover and slide it off. • Connect the battery plug to the socket at the rear of the battery compartment. Make sure the plug is the right way round. The RED and BLACK battery wires must match the RED and BLACK printed on the phone case for the plug to fit properly. Press firmly until it clicks into place. • Position the battery in the compartment and slide the cover into place. Repeat process for second handset (XSR918 only) • Place one handset on the main base and place the other handset on the extra charging cradle. It does not matter which handset is placed on the main base and extra charging cradle. BLACK RED Charging the handset • Charge the handsets uninterrupted for 20-25 hours each. Page iii INSTALLATION If the transferred call is not picked up after 5 minutes, Making a Call Registering Your 2nd Handset Before Using (XSR918 only) After fully charging the handsets, remove the handset from the extra charging cradle and place it on the main base. (The status LED will begin to flash indicating registration is occurring). Wait for at least 5 seconds before removing the extra handset from the main base. The registration has been completed, and your dual handset cordless phone is ready for use. • Pick up the handset and press . Dial the phone number OR Dial the phone number -then press • To hang up -press OR Place the handset on the Base Unit. Call Transfers TO TRANSFER CALLS (XSR918 only) To transfer your call from handset 1 to handset 2: • Press .transfer Answering a Call • Handset on the Base Unit: Remove the handset from the base and speak (Auto Talk). • Handset off the Base Unit: Pick up the handset, press any key and speak. • To hang up -press OR Place the handset on the Base Unit. • The call is placed on hold on the first handset, while handset 2 begins to ring. • The call is transferred when the 2nd handset is answered. the call will be • Repeat the process to transfer the call back to handset 1. Calls can be transferred from either handset. disconnected. Page iv INSTALLATION 4 To turn ON the radio, move the slide switch to the 'on' position. Select modulation by pressing Search for the desired station frequency by pressing Channel or You can automatically search for the next available station frequency by pressing Channel or for 1 second. Press to search for a higher frequency and to search for a lower frequency. The radio's volume can be adjusted using the Volume knob on the side of the base. For Radio Reception; AM Radio: The AM antenna is built into the main base, simply rotate the base for clearest reception. FM Radio: The FM Antenna is the thin wire located at the rear of the main base. Unwind the antenna wire. Keep the antenna wire straight and adjust the position for clearest reception. To turn OFF the radio, move the slide switch to the 'off' position. Using the Radio Page v INSTALLATION Page vi 5 Setting the Clock To change the hour setting, press while pressing . Each press of while pressing increments the hour display by one hour. PM displays for an afternoon time. AM is not displayed. To change the minute setting, press while pressing . Each press of while pressing increments the minute display by one minute. CONTENTS CONTENTS Installation & Safety ..............................................................................i Quick Start Guide Installing the Base Unit..........................................................................ii Installing the Handset Battery...............................................................iii Making a Call ..........................................................