Войти:
Оценок - , средний балл: ( )

Инструкция по эксплуатации Makita, модель 5026DA

Производитель: Makita
Размер: 1.1 mb
Название файла: 5046.pdf

Язык инструкции:en

Документ загружается, подождите пожалуйста
Документ загружается, подождите пожалуйста

Фрагмент инструкции


After adjusting the depth of cut, always tighten the lever securely. Sighting When cutting, align the left side of notch in the front of the base with your cutting line on the workpiece. Dust collection CAUTION: Never cut workpieces covered/stained with thinner, gasoline, oil or the like. If the dust box is stained with them, it may crack, causing an injury to operator. This tool is equipped with the dust box to Dust cap collect dust and cut chips. For the best cut- ting performance, empty the dust box each time the battery cartridge is completely dis- charged. Press the lever and open the dust cap. Tip the rear of the tool down to empty the dust box. Cleaner cutting operations can be per- formed by connecting this tool to Makita vacuum cleaner. Remove the rubber cap from the dust cap and connect the hose of vacuum cleaner to the dust cap. Switch action CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" Dosition when released. To prevent the switch trigger from being accidentally pulled, a lock-off button is prc- Switch trigger - vided. LOCk-off button1 To start the tool, depress the lock-off but- ton and pull the switch trigger. Release the switch trigger to stop. Guide rule The handy guide rule allows you to do extra-accurate straight cuts. Simply slide the guide rule up snugly against the side of the workpiece and secure it in position with the clamp screw on the front of the base. It also makes repeated cuts of uniform width possible. ASSEMBLY Removing or installing the saw blade CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the blade. To remove the blade, first remove the hex socket head bolt which secures the dust box, then remove the dust box. Thumb screw - After installing the blade, install the dust box and tighten the hex socket head bolt to secure the dust box. To remove the blade, press the shaft lock so that the blade cannot revolve and use the hex wrench to loosen the bolt clock- wise. Then remove the bolt, outer flange and blade. Hex wrench (Counterclockwise) Then remove the hex socket head bolt. outer flange and blade. Outer flange Hex socket head bolt To install the blade, follow the removal pro- cedures in reverse. Install the cup washer, inner flange, saw blade, outer flange and hex socket head bolt on the spindle in that order. BE SURE TO TIGHTEN THE HEX SOCKET HEAD BOLT SECURELY. Outer flange Hex socket head bolt CAUTION: Be sure the blade is installed with teeth pointing up at the front of the tool. Use only the Makita hex wrench to install or remove the blade. After install the blade, install the dust box and tighten the hex socket head bolt to secure the dust box. OPERATION Hold the tool firmly. Set the base plate on the workpiece to be cut without the blade making any contact. Then turn the tool on and wait until the blade attains full speed. Now simp...

Эта инструкция также подходит к моделям:
Лобзики и пилы - 5046DWA (1.1 mb)
Лобзики и пилы - 5026DB (1.1 mb)
Лобзики и пилы - 5026DWA (1.1 mb)
Лобзики и пилы - 5026DWB (1.1 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории