This workpiece is small, which will require extra care when cutting or sanding. Please review the safety instructions on your equipment before beginning operation. Making an Inlay Insert Below are six inlay templates that have been printed at actual size. You can use these as a guide for generating the inlay insert in almost any soft, sand-to-shape material, like wood, ivory, shell, or plastics. We recommend that you experiment with the following technique on a test piece before cutting and sh

The job consists of removing the old cutterhead, installing and shimming the new spiral cutterhead, and readjusting the outfeed table even with the carbide inserts at TDC (top dead center). Call Technical Support at (570) 546-9663 if you need help. the t10125 spiral cutterhead is only designed to be used with the grizzly model g0452 6" Jointer. do not install this cutterhead in any other jointer model or make. doing so could result in property damage or serious personal injury. recommended tools

Handle ........................................................ 1 C. Thumbscrew for Handle ............................. 1 D. Clamps ....................................................... 2 E. Meat Alignment Combs..............................2 Figure 1. Model H7779 inventory. D A E CB You MUST clean, thoroughly rinse, and sani- tize all components of this product BEFORE and BETWEEN uses. Failure to follow this warning may lead to sickness or death! NOTICE The Model H7779 is NOT dishwasher safe

Be sure the cord is positioned with a “drip loop” below the level of the outlet as shown above. This prevents water from running down the cord and into the outlet. Instead the water will drip to the floor at the “drip loop” on the cord. To fill the water reservoir: 1. DISCONNECT FROM THE POWER SOURCE. 2. Loosen the tool rest adjustment lock handles and move the tool rest away from the sharpening stone. 3. Fill the water reservoir. See Figure 2 Fill Here Figure 2. Tool rest moved away from sharpe

Place the wheel be- tween two boards, clamp them tightly and keep in a cool dry place for a few hours! Grit Packs containing replacement grit, wax for the gritted wheel and rouge for the slotted wheel can be purchased from ( Item #G5941) . RECOMMENDED SPEED 3000 - 3600 Page Two RAZOR SHARP EDGEMAKING SYSTEM TRUING OF WHEELS: When you have the wheels running “ true” don’t remove them unnecessarily, because when you put them back they will be in a different position and you will have to adjust the

com THE WARRANTY ON THIS PRODUCT IS COMPLETELY UNCONDITIONAL AND FREE OF “ RED TAPE” ! Should you find a manufacturing defect with one of our wheels we will replace it free of charge or refund your purchase price, including shipping. CALL TOLL FREE: 1- 866- 419- 4879 or 1- 877- 725- 2197 RECOMMENDED SPEED 3000 - 3600 RPM Page Four 8x75x625GWWBor8x75x625SWWB Broughttoyouby: Phone: (800) 523-4777 Fax: (800) 438-5901 com This wheel is a replacement wheel ( either gritted or slotted) for the eight i