Оценок - 5, средний балл: 4.6
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Before cleaning your air conditioner, ensure that you have switched off the breaker used for the unit. IMPORTANT Notte If you have not used the air conditioner for a long period of time, set the fan going for three to four hours to dry the inside of the air conditioner thoroughly. 1 Open the front grille by pulling on the tabs on the lower right and left sides of the indoor unit. 2 Disassemble the front grille by pulling it forwards. 6 Reassemble the air filters and the front grille. 3 Hold the edge of the air filter under the front grille and pull to release them. 5 Clean the front panel with a damp cloth and mild detergent (do NOT use benzene, solvents or other chemicals). 4 Remove all dust on the air filters with a vacuum cleaner or brush. E-21 ENGLISH Solving Common Problems Explanation/Solution Check that the breaker used for the air conditioner is switched on. Check that the 5 Way indicator on the indoor unit is on; if necessary press the (On/Off) button on the remote control. Check whether the TIMER indicator on the indoor unit is switched on. If so: - Wait until the switch-on time is reached and the air conditioner starts up automatically - Cancel the timer (see pages 16 and 17 for further details) Check that there are no obstacles between you and the indoor unit. Check the remote control batteries. Check that you are close enough to the indoor unit (seven metres/ yards or less). Check that you are pointing the remote control at the remote control sensor in the right of the indoor unit. Replace the remote control batteries if necessary. Check that the correct operating mode has been selected (AUTO, COOL). The room temperature may be too low. Dust may be blocking the air filter guard; refer to page 20 for cleaning instructions. Check that there is no obstacle in front of the outdoor unit. Check that the operating mode is set to COOL or FAN ; in the AUTO mode, the fan speed changes automatically and in the DRY mode, it is set to AUTO. Check that the air conditioner has been switched on; if necessary, press the (On/Off) button on the remote control. Check that the timer has been programmed correctly; see pages 16 and 17. Air the room. Problem The air conditioner does not operate at all The air conditioner does not operate with the remote control No beep is heard when you press the (On/Off) on the remote control The air conditioner does not cool The fan speed does not change when you press the FAN button The air flow direction does not change when you press the SWING button The timer is not correctly triggered Odours are permeated in the room during air conditioning Before contacting the after-sales service, perform the following simple checks. They may save you the time and expense of an unnecessary call. E-22 Installing a Filter (Option) Deodorizing filter Bio-Pure Filter The air conditioner can be fitted with a deodorizing and Bio-Pure filter to remove minute dust particles or odours. The service life of the filter is appr...
Эта инструкция также подходит к моделям:Кондиционеры - AM14B1E07 (875.88 kb)
Кондиционеры - AM18B1E09 (875.88 kb)
Кондиционеры - AM18B2B09 (875.88 kb)
Кондиционеры - AM18B2B2 (875.88 kb)