|
Фрагмент инструкции
You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded. READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. SAVE THESE INSTRUCTIONS 4 About the controls on the air conditioner. OFF LOW FAN HIGH FAN HIGH HEAT HIGH COOL LOW COOL LOW HEAT WARMER COOLER OFF LOW FAN HIGH FAN HIGH COOL LOW COOL COOLER MODE CONTROL TEMP CONTROL Controls Mode Control HIGH COOL and LOW COOL provide cooling with different fan speeds. HIGH HEAT and LOW HEAT provide heating with different fan speeds. LOW FAN or HIGH FAN provides air circulation and filtering without cooling or heating. NOTE: If you move the switch from a cool or heat setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a cool or heat setting. A 3-minute delay is automatically provided on the Heat/Cool and Heat Pump models. Cooling/Heating Descriptions For Normal Cooling or Heating—Select HIGH COOL or HIGHHEAT with the thermostat at mid point. For Maximum Cooling—Select HIGH COOL with the thermostat at maximum cool. For Maximum Heating—Select HIGH HEAT with the thermostat at maximum heat. For Quieter & Nighttime Cooling—Select LOW COOL with the thermostat at mid point. Temp Control The temp control is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort. When you turn the knob to COOLER (blue) the indoor air will become cooler. Turn the knob to WARMER (red) and the indoor air will become warmer. Heat Pump Models When the outdoor temperature is lower than 25°F., heat is provided by the electric heater in the air conditioner instead of by the heat pump. NOTE: The electric resistance heater in the 115-volt heat pump model operates during defrost when the outdoor coil temperature is below 36°F. It is not intended to provide full heat capability. 5 Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support About the controls on the air conditioner. Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions Fan Switch On Heat/Cool models, the fan switch lever is located in a hole through the control panel. To reach it, you need to remove the front grille. Use a small screwdriver to change the setting. Cool only models have a rocker switch on the front of the control box. When set at CYCLE (down) the fan cycles on and off when cooling or heating. When set at CONT (continuous, up) the fan runs all the time. The unit is shipped in the CONT setting. Temperature Limiting Limiting the maximum and minimum settings prevents users from turning the control to the extreme heat or cool positions. The normal range of the temp control is approximately 60°F to 85°F. The control range may be narrowed by the use of the temperature limiting screws located behind the control panel. Limits Limits heat cool temp temp Each position equals approximately 3°F. Vent Control The vent control is located behind the front grille on the right side of the air discharge area. When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside. To open or close the vent: 1. Remove the front grille. 2. Remove and replace the vent card to the OPEN (mesh end toward the back) or to the CLOSE (mesh end toward the front) position. Open Close Air Direction Horizontal louvers Remove the front on the front grille grille to adjust the let you control the vertical louvers air direction up side-to-side to and down. direct the air left or right. 6 The front grille can be removed for more thorough cleaning or to make the model and serial numbers accessible. To remove: 1. Pull the filter out. 2. Remove the two grille screws. 3. Pull the grille out from the bottom and lift up from the tabs on the top of the case. To replace: Hook the tabs on the front grille even with the tabs on the case and snap into place. Replace the screws and filter. Front Grille Care and cleaning of the air conditioner. Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support Outdoor Coils The coils on the outdoor side of the air conditioner should be checked regularly. If they are clogged with dirt or soot they may be professionally steam cleaned, a service available through your GE service outlet. Grille and Case Turn the air conditioner off and remove the plug from the wall outlet before cleaning. To clean, use water and a mild detergent. Do not use bleach or abrasives. Grille Tab Grille Tab 7 On some models On some models Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions Care and cleaning of the air conditioner. To maintain optimum performance, clean the filter at least every 30 days. Air Filter FRONTFRONT Dirty filt...
Эта инструкция также подходит к моделям:Кондиционеры - 10 ACA (481.9 kb)
Кондиционеры - 12 DCA (481.9 kb)