Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
Otherwise, it might Cause uncomfort and make the room temperature uneven. • Adjust the horizontal air flow louver by using the remote Controller. • Adjust the vertical air flow grilles manually. Adjust the horizontal air flow direction When the air conditioner is operating the horizontal air flow louver may be adjusted to changed the airflow direction as you like. To automatically swing the air flow direction Push the SWING button, horizontal louver swings automatically. The lover will close automatically when the air conditioner stops. CAUTION • The SWING button will be disabled when the air conditioner is not in operation. • Do not set the open angle of horizontal louver too small, otherwise, it will affect the cool or heat effect because of little outlet. By hand • Do not move the horizontal louver manually. If you move the louver manually, it may cause malfunction, stop the air conditioner and restart. • Do not set the open angle of horizontal louver too small. Otherwise, condensation may occur on the surface of the horizontal louver and it cause dew dripping. • When the air conditioner is started immediately after it was stopped, the horizontal louver might not move For 10 seconds or so. When the air conditioner is operating, the vertical louver may be adjusted to change the horizontal air flow. 1. Move the handle outlet left side (or right side) by hand. Adjust the vertical air flow grilles to desired direction to change vertical air flow direction. Vt- 2007-2012.qxd 20.05.04 10:00 Page 10 ~Q- ENGLISH MAINTENANCE Cleaning the indoor unit and the remote controller Before you clean the air conditioner, be sure to disconnect the power supply plug. 1. Use a dry cloth to wipe the indoor unit and remote controller. 2. A cloth dampened with cold water may be used on the indoor unit if it is too dirty. 3. Remove the front panel of indoor unit, clean it with water and wipe it up with a dry cloth. CAUTION • Never use a damp cloth on the remote controller. • Do not use a chemically treated duster for wiping or leave such materials on the unit for long. • Do not use benzine, thinner, polishing powder, or similar solvents for clean. If you do not plan to use the unit for at least one month. 1) Operate the fan for about half a day to dry the inside of the unit. 2) Stop the air conditioner and disconnect power. 3) Remove the batteries from the remote controller. Clean the cleaning filter and refreshing filter Before you clean the air conditioner, be sure to disconnect the power supply plug. It reduces the effect of cooling that the cleaning filter and refreshing filter are covered by dust. So cleaning filter and refreshing filter should often be cleaned. 1. Open the panel and lift the panel up to the angle which remains fixed. Do not lift the panel any further when it stops with a clicking sound. Lift the raise part in the middle of the cleaning filter and pull it out downward. 2. Take the refreshing filter from the cleaning filter. 3. Clean the air cleaning filter with water or vacuum cleaner, then dry it in cool place. 4. Clean the air filter ACTIVE CARBON FILTER/ELECTROSTATIC FILTER Should be cleaned with much duct. Immerse the filter in water with the mild detergent for 20 minutes and wash it slightly (do not rub), then expose it under lig...
Эта инструкция также подходит к моделям:Кондиционеры - VT-2007 (1.24 mb)
Кондиционеры - VT-2009 (1.24 mb)