Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
6 Touch the metal PCI access covers on the back of the computer. Touch the metal portion of the PCI port access covers. Latch Side access panel Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. To avoid static electricity building back up in your body, do not walk around the room until you have completed your installation and closed the computer. 7 Unplug the power cord. 8 Lift the latch on the right side access panel. 9 Gently lower the access panel until it lies flat. To avoid scratching the case, lower the panel onto a soft, clean cloth. 2 - Power Mac G4 Zip Drive Power Mac G4 Zip Drive - 3 Warning: If you see any lights glowing on the main logic board, the computer has not been shut down. Close the side access panel and shut down the computer before proceeding. Removing the Installed Zip Drive 1 Press the clips behind the drive faceplate assembly, rotate the assembly forward until the clips are free of the front panel, and carefully continue rotating the assembly forward to remove it. Gently lower the side panel until it lies flat. Swing the faceplate assembly away from the computer. Unlatch the two plastic clips. 2 Remove the two screws that hold the drive carrier in place and push the carrier forward far enough that you can reach the cables behind it. Note: You will feel some resistance as you push on the carrier. Remove the two screws that secure the drive carrier. 3. Disconnect the ribbon and power cables from the back of the CD/DVD drive. 4. If shielding tape connects the ribbon cable and the carrier, detach the tape from the top of the carrier. 5. Disconnect the ribbon and power cables from the back of the Zip drive. Tape Disconnect the ribbon cable and the power cable from the back of the CD/DVD drive. Disconnect the ribbon cable and the power cable from the back of the Zip drive. 6 Slide the drive carrier assembly the rest of the way out of the computer. 4 - Power Mac G4 Zip Drive Remove the four screws that mount the Zip drive to the carrier and slide the drive out of the carrier. Zip drive Installing the Replacement Zip Drive 1 Slide the replacement Zip drive into the lower bay in the drive carrier. Insert the screws from the old drive through the side holes in the carrier and tighten to secure the drive to the carrier. 2 Partially insert the drive carrier into the computer. Leave room behind the assembly so you can reach the connectors. 3 Connect the cables to the Zip drive and CD/DVD drive: • Connect the middle connector on the power cord bundle to the Zip drive. • Connect the middle connector on the ribbon cable to the Zip drive. • Connect the end of the power cord bundle to the CD/DVD drive. • Connect the end of the ribbon cable to the CD/DVD drive. 4. Reattach the shielding tape (if present) to the top of the carrier. Tape Attach the power cable and the ribbon cable to the back of the CD/DVD drive. Attach the middle connectors on both the power cable and the ribbon cable to the back of the Zip drive. Power Mac G4 Zip Drive -5 5 Push the drive carrier the rest of the way into the computer. Push the drive carrier into the computer until it is firmly seated. This tab must engage this slot when you push the drive carrier back into the computer. 6 Rei...
Эта инструкция также подходит к моделям:Компьютеры - Zip Drive Power Mac G4 (240.64 kb)