Оценок - 5, средний балл: 4.6
(
)
)
|
Фрагмент инструкции
Removing the Installed Zip Drive 1 Press the clips behind the drive faceplate assembly, rotate the assembly forward until the clips are free of the front panel, and carefully continue rotating the assembly forward to remove it. Gently lower the side panel until it lies flat. Swing the faceplate assembly away from the computer. Unlatch the two plastic clips. 2 Remove the two screws that hold the drive carrier in place and push the carrier forward far enough that you can reach the cables behind it. Note: You will feel some resistance as you push on the carrier. Remove the two screws that secure the drive carrier. 3. Disconnect the ribbon and power cables from the back of the CD/DVD drive. 4. If shielding tape connects the ribbon cable and the carrier, detach the tape from the top of the carrier. 5. Disconnect the ribbon and power cables from the back of the Zip drive. Tape Disconnect the ribbon cable and the power cable from the back of the CD/DVD drive. Disconnect the ribbon cable and the power cable from the back of the Zip drive. 6 Slide the drive carrier assembly the rest of the way out of the computer. 4 - Power Mac G4 Zip Drive Remove the four screws that mount the Zip drive to the carrier and slide the drive out of the carrier. Zip drive Installing the Replacement Zip Drive 1 Slide the replacement Zip drive into the lower bay in the drive carrier. Insert the screws from the old drive through the side holes in the carrier and tighten to secure the drive to the carrier. 2 Partially insert the drive carrier into the computer. Leave room behind the assembly so you can reach the connectors. 3 Connect the cables to the Zip drive and CD/DVD drive: • Connect the middle connector on the power cord bundle to the Zip drive. • Connect the middle connector on the ribbon cable to the Zip drive. • Connect the end of the power cord bundle to the CD/DVD drive. • Connect the end of the ribbon cable to the CD/DVD drive. 4. Reattach the shielding tape (if present) to the top of the carrier. Tape Attach the power cable and the ribbon cable to the back of the CD/DVD drive. Attach the middle connectors on both the power cable and the ribbon cable to the back of the Zip drive. Power Mac G4 Zip Drive -5 5 Push the drive carrier the rest of the way into the computer. Push the drive carrier into the computer until it is firmly seated. This tab must engage this slot when you push the drive carrier back into the computer. 6 Reinsert the two carrier mounting screws you removed earlier. Secure the drive carrier to the chassis. 7 Replace the faceplate assembly by aligning its left edge on the computer case, reinserting the clips into their slots on the right side, and pressing the plate until it snaps into place. Replace this edge of the faceplate and swing it into position. 6 - Power Mac G4 Zip Drive Closing the Computer 1 Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place. 2 Reconnect all cables and restart your computer. Warning: Never turn on your computer unless all of its internal and external parts are in place and it is closed. Operating the computer when it is open or missing parts can damage your computer or cause injury. K Apple Computer, Inc. © 2001 Apple Computer, Inc. All rights reserved. Under the copyright laws, this document may not b...
Эта инструкция также подходит к моделям:Компьютеры - Zip Drive 073-0558 (240.64 kb)