Войти:
Оценок - 0, средний балл: 0 ( )

Инструкция по эксплуатации Bosch, модель TAS4211CH/09

Производитель: Bosch
Размер: 10.17 mb
Название файла:
Язык инструкции:itenfrde
Перейти к скачиванию



К этому устройству также есть другие инструкции:

Фрагмент инструкции


There is no power supply. Check that the appliance is properly plugged into the power supply. Machine brews but no drink dispensed. The water tank was removed during the brewing process or there is air in the system. Replace the water tank in the appropriate position in your TASSIMO machine. Start a cleaning process with the Service T DISC. The float in the water tank is stuck. Clean the water tank and ensure the float can move. O Automatic mode not working, appliance remains in stand-by mode. Appliance is not switched on. Make sure the appliance is switched on before inserting a T DISC. No T DISC inserted. Check if T DISC has been inserted. The barcode could not be detected. Clean the bar code reading window and try again or smooth the barcode on the T DISC out with your thumb. Use another T DISC. If problems persist contact the TASSIMO careline. !! Important: – – Bosch only manufactures the TASSIMO brewer. It therefore does not guarantee the availability of TASSIMO T DISCS. – – To find out where to purchase beverage T DISCS go to 01_TAS 40_Heft-GB-CH.indb 13 11.01.2013 14:32:18 14 Robert Bosch Hausgerate GmbH en More Customer Service information is available online at Problem Possible cause Solution O Automatic mode skipped, appliance goes straight to N Manual mode. The barcode could not be detected. Clean the bar code reading window. Use another T DISC. You can still prepare the drink by holding down the start /stop button. The quality of the crema has deteriorated. The drink outlet is clogged or dirty. Remove the drink outlet from the brewing unit and detach the piercing unit. After cleaning everything thoroughly, reassemble the parts and replace them in the brewing unit. Brewing unit cannot be securely closed. Piercing unit / T DISC holder is not properly inserted. Insert the T DISC holder and piercing unit properly. The T DISC is not inserted properly. Re-insert the T DISC and make sure it is properly positioned. The brewing unit is not properly closed. Push the clamp down firmly until it audibly clicks into place. Water dripping from the brewing unit. The T DISC is damaged or leaky. Stop the brewing process, remove the T DISC and clean the brewing unit. The piercing unit is either not inserted or not inserted properly. Check to ensure that the piercing unit is inserted properly. Water on the surface under the cup stand. Water from condensation. Condensation may occur and is not a fault. Remove it by wiping with a cloth. Service T DISC is damaged or lost. The Service T DISC must always be used for cleaning and descaling processes. Look for the Service T DISC in the storage compartment at the back of the appliance. The Service T DISC can be obtained from the Bosch customer service department (article no. 611632, for contact details, see page 59). 01_TAS 40_Heft-GB-CH.indb 14 11.01.2013 14:32:18 15 01/2013 en More Customer Service information is available online at Problem Possible cause Solutio...

Эта инструкция также подходит к моделям:
Кофеварки - TAS4211CH/11 (10.17 mb)
Кофеварки - TAS4211CH/13 (10.17 mb)
Кофеварки - TAS4211CH/15 (10.17 mb)
Кофеварки - TAS4211GB/09 (10.17 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории