Войти:
Оценок - 4, средний балл: 3.8 ( )

Инструкция по эксплуатации Breville, модель ESP6/8

Производитель: Breville
Размер: 253.85 kb
Название файла: dc6fcaea-e6f0-433b-b965-10d99897f189.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


• •• Do not use this appliance for other than its intended use. Do not use outdoors. • •• The appliance is not intended for use by young children or infirm persons without supervision. • •• Young children should be supervised to ensure that they do not play with the appliance. • •• Do not leave the appliance unattended when in use. • •• Do not touch hot surfaces. Use handles. • •• Always use the appliance on a dry, level surface. • •• Do not place this appliance on or near a hot gas or electric burner, or where it could touch a heated oven. • •• Do not let the cord hang over the edge of a table or counter, touch hot surfaces or become knotted. • •• Do not immerse cord, plug or appliance in water or any other liquid. • •• Always switch the appliance to ‘OFF’, switch the power off at the power outlet and then remove the plug when the appliance is not being used and before cleaning. • •• Regularly inspect the supply cord, plug and actual appliance for any damage. If found damaged in any way, immediately cease use of the appliance and return the entire unit to your nearest authorised Breville Service Centre for examination, replacment or repair. • •• Any maintenance other than cleaning should be performed at an authorised Breville Service Centre. • •• The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice. SPECIAL SAFETY INSTRUCTIONS • •• Only use cold water in the water tank. Do not use any other liquid. • •• Never use the machine without water in it. • •• Ensure the filter holder is firmly secured when using the machine. • •• Never remove the filter holder during the brewing operation as the machine is under pressure. Power on/off switch ‘Power On’ light (red) illuminates when the machine is turned on 15 bar Thermoblock pump system Selector Control for Espresso and Steam Filter holder 2 stainless steel filters (1 cup filter and 2 cup filter) Removable 1.2 litre water tank Cup warming plate ‘Heating’ light (orange) illuminates to indicate that the machine is heating and will turn off when the correct temperature has been reached. This light will cycle on and off during operation to indicate the machine is monitoring the correct temperature. External water window Steam wand with froth enhancer Steam baffle Removable drip tray Water level indicator and grid 4 Combined measuring spoon and coffee press 5 OPERATING cont’dOPERATING YOUR ESPRESSO/CAPPUCCINO MACHINE BEFORE USING YOUR ESPRESSO MACHINE Wash the filter holder and the stainless filters in mild detergent and water. Rinse thoroughly. FILLING THE WATER TANK • •• Ensure the Power switch and Selector Control are set to the ‘OFF’ position. • •• Turn off at the power outlet and unplug the power cord. • •• Lift up the water tank lid and remove the water tank. Fill with cold water to the maximum mark and replace in the machine, pressing down firmly so that the water valve opens. Close the water tank lid. PRE-HEATING THE MACHINE For optimal crema, it is recommended to carry out a complete brewing operation with water but without any coffee grinds before making your first coffee to ensure that the machine has been preheated. • •• Make sure the selector control is in the ‘OFF’ position. • •• Plug the power cord into a 230/240V electrical outlet, switch on and set the power switch to the ‘ON’ position. • •• As soon as the orange ‘heating’ light turns off, set the selector control to the ‘ESPRESSO’ position and run a small amount of water through the brewing head for a few seconds without the filter holder in place. PRE-WARMING CUPS For optimal coffee temperature, pre-warm the espresso cups by placing them on the cup warming plate. PREPARING THE COFFEE • •• Place the 1 or 2 cup filter into the filter holder and fill with espresso coffee (use the smaller filter for 1 cup and the larger filter for 2 cups). • •• Use 1 level measure of espresso coffee for the 1 cup filter and 2 level measures for the 2 cup filter. It is important to use the correct amount of coffee as the filter perforations have been constructed for optimal pressure build up in the machine. • •• Distribute the coffee evenly and press it lightly with the bottom of the measuring spoon (if there is too much coffee, the flow of water can become blocked). • •• Clean any excess coffee from the rim of the filter holder to ensure a proper fit under the brew head. • •• Place the filter retainer clip in the release position, by pulling the clip back towards your hand. • •• Place the filter holder underneath the brew head so that the handle is positioned to the left of centre. Lift the filter holder until it contacts the brew head and rotate to the right. • The water tank should be filled with fresh cold water before use...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории