Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
16.6 REMOVING STONES OR OTHER FOREIGN OBJECTS FROM THE BURR GRINDER If the burr grinder is blocked, proceed as follows: • Turn off the machine by pushing the ON/OFF button (Fig. 2,B). Wait until the machine has shut down completely. • Unplug the machine. • Open the bean container and remove all beans (scoop out beans or use a hand-held vacuum cleaner). • Loosen the two screws in the bean container (Fig.24) and remove the bean container (Fig.25). • If any beans remain, remove them. • Attach the burr grinder release tool to the upper burr (Fig.26). • If you cannot find this tool call 1-800-220-5701 and we will send the tool to you free of charge. • Turn the tool counter-clockwise slowly until the stone becomes loose. Attention: Do not try to turn the tool clockwise. • Replace the bean container, and tighten the two screws. • Turn machine on and test the grinder without beans to see if the blockage has disappeared. 23. 16.7 CLEANING METAL CONTACTS EMPTY TRAY/CLEAN CONTACTS • Remove used water tray (Fig.1, 18). • Clean the metal contacts (Fig. 20) with hot water and dish- washing liquid. Use a household brush if necessary. • Replace water tray. COFFEE READY 16.8 CLEANING THE FROTHER SYSTEMS See chapters 14b, 14f and 14g. 16.9 GENERAL CLEANING INSTRUCTIONS Never use abrasive materials or chemicals to clean the machine. • Clean the housing with a soft, damp cloth. • Rinse water tank daily and fill with fresh cold water. 16.10 EMPTYING THE SYSTEM BEFORE TRANSPORT This procedure is necessary to prevent water and frost damage in case you intend to transport the machine. COFFEE READY • Remove the frother system. Leave the steam nozzle attached (Fig. 4). • Place a container under the steam nozzle. • Press the PERMANENT steam button (Fig. 3, M). STEAM INTAKE • Now remove the water tank. The machine will still release some steam. You will hear a knocking noise and the machine will stop after approx. 30 seconds.The display will show PRESS STEAM/ FILL SYSTEM. • Turn off the machine (Fig.2, B). You can now safely transport the machine. • The next time you turn on the machine, proceed as described in chapter 7. 17. AUTOMATIC CLEANING CYCLES 17.1 CLEANING WITH SPECIAL TABLET The machine monitors how many coffees are brewed and how often the rinsing program is activated. After approx. 200 coffees the display will show CLEAN UNIT. You can continue to make coffee, however we highly recommend that you clean the machine as described below within the next few days. This cleaning program will remove oil build-ups in the brewing chamber. If the display shows CLEAN NOW you should clean the machine immediately. There will also be a "beep". This cleaning program takes about 15 minutes. Please use the enclosed white cleaning tablet. The machine comes with a pack of 2 tablets. To re-order see chapter 19. Important: Once the cleaning program has started do not interrupt the procedure. • Make sure the machine is on. • Open the cover (Fig. 1,19) and push and hold the TABLET CLEANING button (Fig. 3A,S) until you hear a beep. EMPTY TRAY (FILL WATER might also show). • Make sure that the water container is at least half full. • Remove and empty the tray and the used bean container and replace. Attention: Even if the tray and the bean container are already empty, you still need to remove 24. the tray for approx. 20 seconds and then replace it. • Place a large container (24 oz.) underneath the coffee spout (Fig.1, 1). ADD TABLET/ PRESS CLEANING • Open the ground coffee funnel lid (Fig.1,10) and drop one white tablet into the opening (Fig.23). • Push the TABLET CLEANING button (Fig.3A,S) again. • The machine will start the automatic cleaning program by dispensing water in intervals into the container underneath the coffee spout. • When finished, the display shows EMPTY TRAY and the machine "beeps". • Remove the tray. There will be water in the tray and in the used coffee container. Empty, clean and replace. RINSE UNIT • Place a cup underneath the coffee spout and push the RINSE button (Fig.2,F). COFFEE READY • Clean the ground coffee funnel after each cleaning cycle. • Remove the funnel and rinse under hot water and dry. • Replace funnel (Fig.21 and 22). 17.2 DECALCIFYING The machine has an integrated decalcifying program. When the shows UNIT CALCED it is time to decalcify the machine. You can still make coffee. However, it is highly recommended that you decalcify the machine within the next 2 days. Note: If you use the Claris water cartridge and the message UNIT CALCED is displayed, then your cartridge function is not activated. Follow the instructions in chapter 11a. Run the decalcifying program only after the machine has been switched off for at least 5 hours and has cooled down completely. IMPORTANT: The decalcifying program must not be interrupted. DECALCIFYING AGENT: Only use our special decalcifying tablets. For supplies see chapter 19. CAUTION: Never use vinegar or any other decalcifying agent. This might damage internal parts of the mach...
Эта инструкция также подходит к моделям:Кофеварки - Impressa S7 (479.73 kb)
Кофеварки - Impressa S9 (479.73 kb)