Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
paint brush). Note: Improper positioning of logs can create carbon build-up and will alter the performance of the appliance. Replacing Logs If the logs become damaged by accident or improper handling and need replacement, use only the proper replacement logs from manufacturer (see Pages 13,14 and 15 for ordering information). Re-Install Embers and Logs Carefully follow placement instructions on Pages 12 through 15. All logs should fit onto corresponding pins and/or log stoppers. This will ensure a proper flame and safe combustion. Inspect Wiring Refer to wiring diagrams on Page 18. CAUTION:Whenservicing controls,label all wires prior to disconnection. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. ATTENTION: Au moment de l'entretien des commandes, etiquetez tous les fils avant de les debrancher. Des erreurs de cablage peuvent entrainer un fonctionnement inadequat et dangereux. Inspect and clean all wire connections. Ensure that there is no melting or damage. Inspection should include: • Terminals at the Valve • OFF/ON Switch • (Optional Control Switch) Wall Thermostat, Remote Control or Remote Wall Switch Kit Inspect Burner Flame Appearance Ensure that the burner flame appearance resembles the flame shown in Figures 12, 13 and 14 and as described in Flame Appearance andSooting on Page 16. The Homeowner must contact a qualified service technician at once if any abnormal condition is observed. Small Area Paint Touch-up The finish of the appliance is a high-quality powdercoat. Only use factory supplied powdercoat paint kit for touch-ups. Paint is available at your local authorized Lennox Hearth Products dealer. Never attempt to paint a hot fireplace. Do not attempt to repaint the appliance until the finish is completely cured (see Burn-In Period on Page 7). If the surface later becomes stained or marred, it may be lightly sanded and touched up with spray paint. 11 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. SUPERIOR® DIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS Figure 6 Front Glass Enclosure Panel, Removal and Installation Control Compartment Panel Hood Glass Door Header Spacing Top Standoffs Flush Nailing Flange 1/2” Nailing Flange 5/8” Nailing Flange Glass Door Spring Latch WARNING Any safety screen or guard removed for servicing the appliance must be replaced prior to operating the appliance. AVERTISSEMENT Tout ecran ou protecteur retire pour permettre l’entretien de l’appareil doit etre remis en place avant de mettre l’appareil en marche. WARNING • Do not attempt to substitute the materials used on this door, or replace cracked or broken glass. • Handle this glass with extreme care! Glass is susceptible to damage – Do not scratch or handle roughly while reinstalling the glass door frame. • The glass door(s) of this appliance must only be replaced as a complete unit as provided by the manufacturer. Do not attempt to replace broken, cracked or chipp...
Эта инструкция также подходит к моделям:Камины - SLDVT-30NE (2.16 mb)
Камины - SLDVT-30NE (2.16 mb)
Камины - SLDVT-30NE (2.16 mb)
Камины - SLDVT-30NE (2.16 mb)