Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
Refer to the Lighting Instructions on Page 24 to lighttheapplianceintheeventofapowerfailure. Figure 3 - SIT Millivolt Gas Valve Gas Inlet Terminals TPTH, TP and TH Gas Outlet Variable Flame Height Adjustment Manifold Pressure PortInlet Pressure Port Main Gas Control Knob HI LOW TPTH TP TH PILOT PILOTON itOFF IN OUT Pressure-Tap Burner Stage (Manifold) Terminal Regulator Gas Supply Gas Mounting Outlet Inlet Screw To Burner Pressure-Tap Pilot Stage (Inlet) Terminal Pilot Gas Outlet Ground (TP) PILOTOUTVENTLOTHTPTHTPHIININ Figure 4 - Dexen Electronic Gas Valve Variable Flame Height Adjustment All millivolt and electronic appliances are equippedwithavariablegascontrolvalve.Flame heightforthesemodelsmaybeadjustedthrough arangebetweenfixedlowandhighsettingswhile the appliance is in operation. Adjust the flame height as desired after lighting the appliance by rotating the variable adjustment control knob (HI/LO) located on the front of the valve (refer to Figures 3 and 4). SUPERIORSUPERIORDIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS MAINTENANCE (See Maintenance Schedule, Page 26) Refertothemaintenancescheduleformaintenance tasks, procedures, periodicity and by whom they shouldbeperformed. Alwaysverifyproperoperation of the appliance after servicing. WARNING Turn off gas and electrical power to the fireplace and allow it to coolbefore cleaning or servicing the appliance. CAUTION: Wear gloves and safety glasses for protection while doing required maintenance. Verify proper operation after servicing. S'assurer que l'appareil fonctionne adequatement une fois l'entretien termine. Always turn off gas to the pilot (millivolt appliances) before cleaning. Before relighting, refer to the lighting instructions inthismanual.Instructionsarealsofound on a pull-out panel located in the control compartment. Before re-lighting the fireplace, refer to the lighting instructions in this manual. Instructions are also found on pull-out panels located below the glass door in the control compartment. Inspect Venting System The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service technician (inspection should include ensuring that exhaust or intake passages are unobstructed and vent components are properly assembled and not damaged). Homeowner must contact a qualified service technician at once if any abnormal condition is observed. If the venting system is disassembled for any reason, a qualified service technician should follow vent installation instructions for proper reassembly and proper sealing of the venting system components. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Cleaning Glass (Also see Front Glass Enclosure Panel, Removal and Installation on Page 11). Note: Clean glass after first two weeks of operation (after Burn-In period is over) and then only when necessary and only when the fireplace is cool. ...
Эта инструкция также подходит к моделям:Камины - SLDVT-30NE (2.16 mb)
Камины - SLDVT-30NE (2.16 mb)
Камины - SLDVT-30NE (2.16 mb)
Камины - SLDVT-30NE (2.16 mb)