Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
This kit can be retrofitted to previously installed appliances and may be temporarily installed in place of other switch circuitry. Wall Thermostat Kit A wall thermostat kit is available for use with the millivolt controlled appliances. The wall thermostat is designed to be wired directly to the appliance millivolt gas control circuit and provide automatic On/Off control of the appliance to maintain a desired temperature within the room. OPERATION AND CARE OF YOUR APPLIANCE 1. Blower operation may be controlled through the ON/OFF unit rocker switch, located in the lower control compartment. 2. These heater rated units are equipped with a two stage (HI, LOW) gas control valve. To set the burner at the HI and LOW settings, rotate the control knob to the desired position. 3. When lit for the first time, the appliance will emit a slight odor for an hour or two. This is due to the “burn-in” of the internal paints and lubricants used in the manufacturing process. Additionally, when lit for the first time, this appliance may produce smoke, this is normal and should be expected. For the first few hours, operate the appliance with doors and windows open to encourage the dissipation of smoke and fumes. 4. Keep lower control compartment clean by vacuuming or brushing at least twice a year. More frequent cleanings may be required due to excessive lint from carpeting, bedding materials, etc. It is important that the control compartments, burners and circulating air passageways of the heater be kept clean. 5. Always turn off gas to pilot before cleaning. Before relighting, refer to the lighting instructions in this manual. Instructions are also found on a pull-out panel located on the floor of the appliance. 6. Always keep the appliance area clear and free from combustible materials, gasoline and other flammable liquids. 7. Remember, this appliance has a continuous burning pilot flame. Exercise caution when using products with combustible vapors. CLEANING AND SERVICING WARNING: TURN OFF THE UNVENTEDGAS ROOM HEATER AND ALLOW TO COOLBEFORE CLEANING. Only limited cleaning will be required under the normal use of the heater. Dust the front grate, the top of the piezo cover and the control knob occasionally. Do not use cleaning fluids to clean the logs or any other part of the room heater. Remove the log assembly, gently handling by holding each log at each end. Use a vacuum cleaner to remove loose particles from the base and from around the burners. Gloves are recommended to prevent the fibers from pricking your skin. If the skin is pricked, wash gently with soap and water. Replace the logs as detailed in Step 12 Assembling the Logs. If, after a period of use, the flames start to exhibit unusual shapes and behavior, or the burners fail to ignite smoothly, then the burner holes may require some cleaning. If this happens, it is preferable to contact your nearest dealer to get the appliance serviced. REPLACEMENT PARTS An exploded view of the room heater with numbered...
Эта инструкция также подходит к моделям:Камины - VF4000-CHN-2 (1 mb)
Камины - VF4000-CHP-2 (1 mb)
Камины - VF4000-CHN-2 (1 mb)
Камины - VF4000-CHN-2 (1 mb)