Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Figure 8 BURNER POSITIONING REAR BURNER FRONT BURNER PILOT BURNER Note: The burners are not identical. Position them so that the circular burner ports run as shown. Note especially the vertical run of ports relative to the pilot burner. Bracket A on the rear burner will interfere with the pilot burner if an attempt is made to install the rear burner in the front burner’s position. BRACKET A BURNER PORTS NOTE: INSTALL REAR BURNER FIRST, THEN FRONT BURNER. Figure 7 Volcanic Stone Unitized Log Set Proper Burner Flame Appearance Figure 5 WARNINGS • This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to appliance and prove hazardous to your safety. • If logs are not installed according to the log installation instructions, flame impingement and improper combustion could occur and result in soot and/or excessive production of carbon monoxide (CO), a colorless, odorless, toxic gas. Burner / Grate Location Reference (see Figures 5 to 8) Note: If the burners have been removed for any reason, rear burner must be installed before front burner. See Figures 7 and 8. Install the decorative volcanic stone and glowing embers (rockwool): Spread the decorative volcanic stone on the simulated brick floor of the firebox around the burners to simulate ashes. Maintain a 1/2 inch (13 mm) gap between the bottom of the horizontal grate section and the top of the pile of decorative volcanic stone. Place a few quarter- sized pieces of the glowing ember material on the pan burner in front of the burned out area on both sides of the log set. The glowing embers may touch one another, but should not overlap each other. Glowing Embers Bag of Glowing Embers (rockwool) Separate into Quarter Size (separate) Pieces Figure 6 REFERENCE Firebox Accessories / Parts Cat. No. Model No. Description 88L53 FGE Bag of Glowing Embers 80L42 FDVS Bag of Decorative Volcanic Stone Install the unitized log set: a. The bottom of the log set is notched to accommodate the pilot. b. .Place the log set so that the four inner notches on the underside of the log set fit over the four risers located on the burner ends. See Figures 5, 7 and 8. This procedure is accomplished primarily by feel, as the log set masks the burner risers as it is being installed. c. As a final check for correct log set placement, check that the four outer notches on the underside of the log set fit over the burner tines as indicated in Figures 5, 7 and 8. BURNER ADjUSTMENTS (QUALIFIED TECHNICIANS ONLY) BURNER ADjUSTMENTS (QUALIFIED TECHNICIANS ONLY) Proper flame appearance is a flame which is blue at the base and becomes yellowish-orange in the body of the flame. When the appliance is first lit, the entire flame may be blue and will gradually turn yellowish-orange during the first 15 minutes of operation. After 15 minutes of operation, if the flame is blue, or if the flame is orange with evidence of sooting (black tip), the air shutter opening may need to be adjusted. If the air shutter openings are closed too far, sooting may develop. Sooting is indicated by black puffs developing at the tips of very long orangeflames. Sootingresultsinblackdeposits forming on the logs, appliance inside surfaces and on exterior surfaces adjacent to the vent termination. Sooting is caused by incomplete combustion in the flames and lack of combustion ...
Эта инструкция также подходит к моделям:Камины - SDV SDVPF-N-B (2.24 mb)
Камины - SDV SDVPF-N-B (2.24 mb)
Камины - SDV SDVPF-N-B (2.24 mb)
Камины - SDV SDVST-N-B (2.24 mb)