Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Flame height for these models may be adjusted through a range between fixed low and high settings while the appliance is in operation. Adjust the flame height as desired after lighting the appliance by rotating the variable adjustment control knob (HI/LO) located on the front of the valve (refer to Figure 3). NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. MAINTENANCE MAINTENANCE Refer to the maintenance schedule for maintenance tasks, procedures, frequency and bywhom they should be performed. Always verify proper operation of the appliance after servicing. WARNING Turn off gas and electrical power to the fireplace and allow it to coolbefore cleaning or servicing the appliance. CAUTION: Wear gloves and safety glasses for protection while doing required maintenance. Verify proper operation after servicing. S'assurer que l'appareil fonctionne adequatement une fois l'entretien termine. Always turn off gas to the pilot (millivolt appliances) before cleaning. Before relighting, refer to the lighting instructions inthismanual.Instructionsarealsofound on a pull-out panel located in the control compartment. Inspect Venting System The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service technician (inspection should include ensuring that exhaust or intake passages are unobstructed and vent components are properly assembled and not damaged). Homeowner must contact a qualified service technician at once if any abnormal condition is observed. If the venting system is disassembled for any reason, a qualified service technician should follow vent installation instructions for proper reassembly and proper sealing of the venting system components. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Cleaning Glass (see Front Glass Enclosure Panel, Removal and Installation on Page 11). Note: Clean glass after first two weeks of operation (after Burn-In period is over) and then only when necessary and when the fireplace is cool. Wipe surface with clean, dampened, soft cloth. Follow with a dry, soft towel as desired. Take care not to scratch the glass surface. IMPORTANT: Do not use abrasive cleaners on glass. Never clean the glass when it is hot. The viewing glass should be cleaned periodically to remove any build-up caused from the following: • During start-up, it is normal for condensation to form on the inside of the glass (this condensation and fog will usually disappear in a few minutes). The moisture can cause lint,dustandother airborneparticlestocling to the glass surface. • Initial curing of the high temperature paint and burning off of lubricants used in the manufacturing process may result in a film on the glass. • A white coating may form on the glass as a result of impurities and minerals in the fuel. It is recommended that the glass be cleaned two or three times during each heating season, depending on the circumstances present. The following cleaning solutions are approved for use to clean glass: • Non-ammonia based household cleaner • 50%-50% mix of white vinegar & water • gas fireplace/stove glass cleaner Inspect Glass Gasket -Visually inspect the gasket on the backside of the glass enclosure panels. The gasket surface must be clean, free of irregularities and seated firmly. Clean Lo...
Эта инструкция также подходит к моделям:Камины - SDV SDVPF-N-B (2.24 mb)
Камины - SDV SDVPF-N-B (2.24 mb)
Камины - SDV SDVST-N-B (2.24 mb)
Камины - SDV SDVST-N-B (2.24 mb)