Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
For older units, remove the glass. Remove the face connector bracket Re-attach the face connector to the from the heater (on both sides). heater using the forward mounting holes. Warnings Warning: Make sure the heater has fully cooled prior to conducting service. Hand-Rubbed Patina Finishes The optional patina finish is hand applied by a skilled artisan to permanently alter the metal colors and texture of the face. Each face is individually hand-polished and fired in an oven which imparts unique color subtleties with no two finishes alike. The patina finish on your face is a “living” color and will age and antique over time. Enjoy the timeless, rich luster of your beautiful new face._ Page 1 of 3 17601079 - 9/14/11 © Travis Industries, Inc. FPX 32 DVS Artisan Face Xtrordinair {or 6twry io* Charcoal: 98500507 Patina Bronze: 95300398 Bracket Installation NOTE: The brackets install with this pair of closely spaced flanges at the top. in Face Installation Page 2 of 3 17601079 - 9/14/11 © Travis Industries, Inc. ft Fireplace XrRORDINAIR„ FPX 32 DVS Artisan Face Charcoal: 98500507 Patina Bronze: 95300398 Opening the Control Door Warning: The face becomes very hot during operation. Use the included handle open the control and take care to not touch any of the hot surfaces. Use the pull tool on either side to disengage the hinges. Control Door Note how the hooks on the tool insert into the triangle-shaped holes. When removing the pull tool, make sure it does not damage the hearth. Adjusting the Control Door The control is adjusted at the factory. See the directions below if further adjustment is necessary. Bullet Catch Back of Face (with face removed) Back of Bullet Catch Access Panel These two nuts hold the bullet catch assembly. If the top of the control door is not aligned, these nuts can be loosened to re-align the bullet catch assembly. This bullet-shaped device holds the control door upright. To tighten or loosen the catch, simple rotate it (it is threaded inside the assembly). Adjust this nut to tighten or loosen the friction of the hinge. Page 3 of 3 17601079 - 9/14/11 © Travis Industries, Inc....