Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
IMPORTANT: If installing a gas fireplace, vertical support will be installed to mantel assembly after gas fireplace has been installed. If installing electric fireplace, first install vertical support and install fireplace from front of mantel. Do not put any weight on mantel top until vertical support has been installed. Fireplace Installation 1. Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual. 2. Mantel must be installed flush with two walls. Remove baseboard along walls where mantel is to be installed. Baseboard will prevent proper installation of mantel and base. 3. Place mantel base close to installation location. See fireplace owner’s manual for installation clearances. Leave enough room to insert fireplace from back of mantel. 4. If installing gas fireplace, install gas line. See Connecting to Gas Supply in fireplace owner’s manual. Remember to leave access to gas shutoff valve somewhere on mantel base or where it is accessible to user. Check for leaks. See Checking Gas Connections in fireplace owner’s manual. 5. Position fireplace inside mantel through back opening (see Figure 6). Carefully position gas lines if applicable. Important : Use caution when positioning fireplace on base. Base may scratch easily. Make sure fireplace is in proper position within mantel opening before continuing with installation. 6. Gas fireplace with louver door: Lower bottom louver door. Use two screws provided in fireplace hardware kit and attach fireplace to wooden base. Close louver door. Gas fireplace with fixed louver: Before installing logs or burner assembly (see owner’s manual) remove screws securing floor to assembly. Lift floor for access to bottom of fireplace. Use two screws provided in fireplace hardware kit and attach fireplace base to wooden base. Reinstall floor with screws removed previously. Mantel Top Assembly Assembly Blocks Assembly Blocks 11/4" Screws Corner of Mantel Legs Must be Flush with Edge of Mantel Top Mantel Legs Flush with Mantel Base Figure 5 - Installing Mantel Top Figure 6 - Installing Gas Fireplace Electric Fireplace Installation This mantel can be used with DESA Heating, LLC electric fireplaces. Electric fireplaces install from the front of mantel. To install electric fireplace see fireplace instruction manual. Vertical Support Installation Install vertical support (see Figure 7). Mantel Instalation 1. Carefully push mantel and base into position in corner and flush against both walls. Check operation of fireplace before proceeding. 2. Place right trim strip on right side of top and left trim on left side of top. Align both pieces so any gaps between mantel and wall are covered as well as possible and front of trim strips are flush with side of top. With one person holding trim strips in place, nail each strip to mantle using finishing nails included in hardware kit and nail set. Top Center Support Finishing Nails Trim Strips Vertical Support #11 1 1/4" Screws Figure 8 - Installing Mantel Trim Base Support #10 1 1/4" Screws Figure 7 - Installing Vertical Support DESA Heating, LLC 2701 Industrial Drive Bowling Green, KY 42101 1-866-672-6040 123680 01 123680-01 Rev. A 04/08 NOT A UPC ...
Эта инструкция также подходит к моделям:Электрообогреватели - C36TO (414.19 kb)