Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Do not use mantel with any other product. This mantel kit contains the following: • Mantel pieces - unassembled and numbered as follows: #1 Base #2 Right Side Assembly #3 Left Side Assembly #4 Header #5 Top #6 Top Triangle #7 Top Left Support #8 Top Right Support #9 Top Center Support #10 Base Support #11 Vertical Support Right Top Trim Strip Left Top Trim Strip • Hardware Package 36 - 1 1/4" Wood Screws 114325-01 8 - 1" Finishing Nails 114295-04 4 - 2" Wood Screws 122447-01 * Extra hardware may be included Tools required: • Power Screwdriver with #2 Phillips Bit • Hammer • Nail Set If any wood pieces are missing or damaged, contact the dealer where you purchased this mantel for replacement. If hardware is missing or damaged, contact DESA Heating, LLC at 1-866-672-6040 for referral information. You can also visit DESA Heating, LLC’s web site at WARNING: Follow guidelines of paint or finish manufacturer. Use care when finishing or painting an unfinished mantel (C36TU only). Do not finish or paint mantel pieces near running heater or open flame. These vapors are highly flammable. IMPORTANT: If you are staining an unfinished mantel (C36TU only), remove any sawdust, dirt or oils. This will prevent blemishes from appearing under the stain. Stain mantel before assembling according to manufacturer’s instructions. Apply sanding sealer. IMPORTANT: If you are painting an unfinished mantel (C36TU only), assemble mantel before painting. Follow directions listed on paint for wood products. Apply base coat and top coat following directions listed on product. Note: Gather all mantel pieces together before assembling mantel. WARNING: Only use 1 1/4" screws to assemble mantel. Damage to mantel will result if other screws are used for this purpose. 123680-01A Asse mbling Mantel IMPORTANT : More than one person is required to lift assembled mantel. Lift mantel by leg assemblies. Lifting by header or mantel top could damage mantel. Use the following illustrations to assemble mantel. Use only screws provided. IMPORTANT: Align mantel left to right on base before installing. Corner of mantel legs must be flush with back of mantel base before installation (see Figure 4). Use a tape measure to insure accuracy. IMPORTANT: Use 2" screws only on top center support. Using 2" screws in any other location will damage mantel. Right Leg Assembly #2 11/4" Screws Left Leg Assembly #3 11/4" Screws Base #1 Base #1 Figure 3 - Installing Mantel Base Base Support #10 2" Screws Figure 1 - Installing Base Support Top Center Support #9 Header #4 Right Leg Assembly #2 Mantel Top #5 11/4" Screws Header into Groove on Legs Header Assembly Block Top Left Support #8 Top Right Support #8 Top Triangle #6 11/4" Screws Figure 4 - Mantel Top Assembly Left Leg Assembly #3 Figure 2 - Installing Header 123680-01A IMPORTANT: Align mantel top left to right before installing. Back corner of mantel leg must be flush with edge of mantel top before installation. IMPORTANT: If installing a gas fireplace, vertical support will be installed to mantel assembly after gas fireplace has been installed. If installing electric fireplace, first install vertical support and install fireplace from front...
Эта инструкция также подходит к моделям:Электрообогреватели - C36TU (414.19 kb)