Оценок - 2, средний балл: 5 ( )

Производитель: Creda Размер: 1.56 mb Название файла: Язык инструкции:

Higher temperature settings range from 1 to 6 (max.) creating a maximum room temperature of approximately 30°C. Switch on the heater and turn the thermostat knob to the position corresponding to the required temperature for the room. The heater will then maintain the room temperature at the chosen level, provided that the correct size of heater has been selected for the room to be heated. NOTE - Should your heater fail to come on when the thermostat knob is at a low setting, this may be due to the room temperature being higher than the thermostat setting. Operation - TW Models - Thermostat and Timer Control of Output and Temperature (see Fig. 5) The slide switch on the timer unit controls the electricity supply to the heating elements on TW models. Fig.5 Thermostat Operation - see above. Using the Timer The heater must be connected to the electricity supply for the timer to operate. Set the timer by rotating the dial clockwise until the correct time of day is indicated opposite the datum mark (located at centre front of the timer - see Fig. 5). 'OFF’ Position Set the timer switch to • position. The timer operates but the heater will not output any heat, as the electricity supply to the heating elements has been disconnected. Manual Operation Set the timer switch to .. position. The heater will now operate continuously under the control of the thermostat - see 'Thermostat Operation' above. Automatic Operation Set the timer switch to .. position. The panel will now operate during set 'ON' periods under the control of the thermostat. To set the timer's 'ON' and 'OFF' periods: 1. Using your finger tip or the tip of Fig. 6 a pencil, push in as many segments as necessary around the dial, according to the times you don't require heat - see Fig. 6. Each segment pushed in switches the heater OFF for that part of the hour. All other segments will be 'ON'. 2. You can select as many 'ON' periods as you like, within the 24-hour day. The settings will repeat every day until changed. 3. To change 'ON' and 'OFF' times, simply push in any 'ON' segments you wish to cancel and pull out new 'ON' segments as required. Note: On T models each segment on the timer represents 20 mins. Setting the Time The current time is set by rotating the timer dial clockwise until the correct time is indicated opposite the datum mark. Safety - Overheat protection For your safety this appliance is fitted with a thermal cut-out. In the event that the product overheats for some reason, the cut-out prevents excessive temperatures on the product by cutting the power to the heater. Once the heater has cooled down, it will reset automatically. It will continue to cycle on and off automatically until the reason for overheating is removed. Cleaning Before commencing cleaning, unplug the heater and allow it to cool. Disconnect the electricity supply to the appliance. The outside can be cleaned by wiping it over with a soft damp cloth and then dried. Do not use abrasive cleaning powders or furni...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: