Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
Be prepared if a fire starts. INSPECT SPACE HEATER Be sure all covers, guards and shields are tight and in place. Locate all operating controls and safety labels. Inspect power cord for damage before using. There is a hazard of electrical shock from crushing, cutting or heat damage. Remove all packing items applied to space heater for shipment. Remove all items from carton. Check items for any shipping damage. If space heater is damaged, promptly inform dealer where you bought space heater. SERVICE SPACE HEATER SAFELY Before servicing the space heater, disconnect all equipment and battery (if equipped) and allow unit to cool down. Service space heater in a clean dry flat area. Operator’s Manual 10 Operator’s Manual Controls A -- Hot Air Outlet B -- Thermostat Knob C -- Fan Guard D -- ON / OFF Switch w/ Light E -- Ignition Control Assembly (On Inside of Side Cover) F -- Side Cover CONTROLS A B C D E F G H I A B C E D F G H A B C E D G F H AC-70 AC-115 AC-165 G -- Fuel Cap / Gauge H -- Fuel Tank I -- Air Filter End Cover Assembly ASSEMBLY WheelSupportFrameFuelTankFlangeCapNutWheelNutAxleExtendedHubAirInletHandleHotAirOutletScrewWheelSpacer(IfProvided) BoltsandNuts HandleCord Cleat with NOTE: For 115 and 165 Models Only These models are furnished with wheels and a handle. Some models are furnished with a second handle also. Wheels, handle(s), and the mounting hardware are found in the shipping carton. Tools Needed • Medium Phillips Screwdriver • 3/8" Open or Adjustable Wrench • Hammer 1. Slide axle through wheel support frame. Install wheel spacers if provided. Install wheels on axle. IMPORTANT: When installing wheels, point extended hub of wheels toward wheel support frame (Fig. 1). 2. Place cap nuts on axle ends. Gently tap with hammer to secure. 3. Place space heater on wheel support frame. Line up holes on fuel tank flange with holes on wheel support frame. 4. Place handle(s) on top of fuel tank flange. Insert screws through handle(s), fuel tank flange, and wheel support frame. Attach nut, hand tight after each screw (Fig. 1) is inserted. 5. After all screws are inserted, tighten nuts firmly. Operator’s Manual 12 Operator’s Manual Preparation VENTILATION WARNING: PROVIDE A FRESH AIR OPENING OF AT LEAST THREE SQUARE FEET (2,800 SQUARE CM) FOR EACH 100,000 BTU / HR RATING. PROVIDE EXTRA FRESH AIR IF MORE SPACE HEATERS ARE BEING USED. THE MINIMUM VENTILATION REQUIREMENTS MUST BE FOLLOWED TO AVOID RISKS ASSOCIATED WITH CARBON MONOXIDE POISONING. MAKE CERTAIN THESE REQUIREMENTS ARE MET PRIOR TO OPERATING SPACE HEATER. Example: A 200,000 Btu / Hr (58.6kw) space heater requires one of the following: • a two-car garage door [16 feet (4.88 meter) opening] raised 5 inches (12.7 cm) • a single-car garage door [9 feet (2.74 meter) opening] raised 8 inches (20.3 cm) • two, 30 inch (76.2 cm) windows raised 15 inches (38.1 cm) FUELS WARNING: USE ONLY KEROSENE, #1/#2 DIESEL/ FUEL OIL, JET A OR JP8 FUELS TO AVOID RISK OF FIRE OR EXPLOSION. NEVER USE GASOLINE, OIL DRAINED FROM CRANKCASES, NAPHTHA, PAINT THINNERS, ALCOHOL OR OTHER HIGHLY FLAMMABLE FUELS. Use only kerosene, #1/#2 diesel / fuel oil, JET A or JP-8 fuels. Heavier fuels such as No. 2 fuel oil or No. 2 diesel fuel may also be used but will result in: • noticeable odor • additional fuel filter maintenance • the need for nontoxic, anti-icer additives in very cold weather Do not use fuels heavier than No. 2 grade or heavy oils such as oil drained from crankcases. These heavy oils will not ignite properly and will contaminate the space heater. IMPORTANT: Use a KEROSENE ONLY (blue) or DIESEL ONLY (yellow) storage container. Be sure storage container is clean. Foreign matter such as rust, dirt, or water will cause the ignition control assembly to shut down space heater. Foreign matter may also require space heater’s fuel system to be frequently cleaned. Preparation THEORY OF OPERATION The Fuel System: The air pump forces air through the air line. The air is then pushed through the nozzle. This air causes fuel to be lifted from the tank. A fine mist of fuel is sprayed into the combustion chamber. The Air System: The motor turns the fan. The fan pushes air into and around the combustion chamber. This air is heated and provides a stream of clean, hot air. The Ignition System: The ignition control assembly provides power to the ignitor. This ignites the fuel / air mixture in the combustion chamber. The Flame-Out Control System: This system causes the space heater to shut down if the flame goes out. Clean Heated Air Out Fuel Filter Air Line To Burner Air Output Filter Air PumpAir Intake Filter Cool Air In Fan Combustion Chamber Ignitor Ignition Control Assembly Air For Fuel System Air For Combustion And Heating Fuel Nozzle Fuel Tank Motor Operator’s Manual Operation OPERATION IMPORTANT: Review and understand the warnings in the Safety Information section. They are needed to safely operate this space heater. Follow all local ordinances and codes when using this space heater. ...
Эта инструкция также подходит к моделям:Электрообогреватели - AC-115 (2.44 mb)
Электрообогреватели - AC-165 (2.44 mb)