|
Фрагмент инструкции
(Fiberglass wool is known to the State of California to cause cancer.) Fiberglass wool may also cause respiratory, skin, and eye irritation. To reduce exposure to this substance or for further information, consult material safety data sheets available from address shown below, or contact your supervisor. P.O. Box 799900 Dallas, TX 75379.9900 WARNING Do not use this furnace if any part has been under water. A flood.damaged furnace is extremely dan gerous. Attempts to use the furnace can result in fire or explosion. A qualified service agency should be contacted to inspect the furnace and to replace all gas controls, control system parts, electrical parts that have been wet or the furnace if deemed necessary. WARNING Electric shock hazard. Can cause injury or death. Before attempting to perform any service or maintenance, turn the electrical power to unit OFF at disconnect switch(es). Unit may have multiple power supplies. WARNING Danger of explosion. Can cause injury or product or property damage. Should the gas supply fail to shut off or if overheating occurs, shut off the gas valve to the furnace before shutting off the electrical supply. WARNING Danger of explosion and fire. Failure to follow safety warnings exactly could result in dangerous operation, serious injury, death or property damage. CAUTION Label all wires prior to disconnection when servic ing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. Page 1 WARNING Danger of electrical shock, explosion and fire. Improper servicing could result in dangerous operation, serious inujry, death or property damage. Unit Operation FOR YOUR SAFETY READ BEFORE LIGHTING BEFORE LIGHTING smell all around the furnace area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion. This unit is equipped with an automatic spark ignition sys tem. There is no pilot. In case of a safety shutdown, move thermostat switch to OFF and return the thermostat switch to HEAT. Electro.mechanical thermostat is shown in figure 1. On logic units and units with electronic temper ature controls, shut main disconnect off and back on to re set ignition control. Unit Operation . Continued THERMOSTAT HEAT COOL FAN 50 60 70 80 10 15 2025 30 HEAT OFF COOLAUTO ON FIGURE 1 A.Placing Unit In Heating Operation WARNING Danger of explosion and fire. Can cause injury or product or property damage. You must follow these instructions exactly. 1. If using electromechanical thermostat, set to the low est setting. 2. Turn off all electrical power to furnace. 3. This furnace is equipped with an ignition device which automatically lights burner. Do not try to light burner by hand. 4. Remove hea...
Эта инструкция также подходит к моделям:Электрообогреватели - GCS20-048 (163.84 kb)
Электрообогреватели - GCS20-036 (163.84 kb)
Электрообогреватели - GCS20-030 (163.84 kb)
Электрообогреватели - GCS20-024 (163.84 kb)