(0 dBm to +13 dBm) Square wave: 0.2 Vpk-pk to 2.8 Vpk-pk into 50 . — Maximum Input Overload ±10 V — Input Impedance 50 . — Input Coupling AC — © National Instruments Corporation 19 NI 5421 Specifications PFI 0 and PFI 1 PFI 0 and PFI 1 Table 6. Specification Value Comments Connectors Two SMB (jack) — Direction Bi-directional — Frequency Range DC to 105 MHz — As an Input (Trigger) Destinations Start Trigger — Maximum Input Overload –2 V to +7 V — VIH 2.0 V VIL 0.8 V Input Impedance 1 k. As an Out

Starting the Engine 1 Make sure the circuit breaker light switches are in the off position. 2 At the control panel, turn the key or turn the switch to the run position. The glow plug light will come on. 3 Wait for the glow plug light to go off. 4 Turn the key or turn the switch to start. Note: If the key or switch is not turned to start within 10 seconds of the glow plug light going off, the engine may fail to start. If this happens, turn the key or switch to the off position and repeat the proc

97600 Genie TML-4000 andTML-4000N Operator's Manual Third Edition • Second Printing Pre-operation Inspection Do Not Operate Unless: You learn and practice the principles of safe machine operation contained in this operator’s manual. 1 Avoid hazardous situations. 2 Always perform a pre-operation inspection. Know and understand the pre-operation inspection before going on to the next section. 3 Always perform the function tests prior to use. 4 Inspect the workplace. 5 Only use the machine as it wa