Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
Make sure any loose fittings, bolts, etc., are tightened before putting unit into service. General Safety 1. Before starting or servicing any generator, read and understand all instructions. Failure MANUAL to follow safety precautions or instructions can cause equipment damage and/or serious personal injury. Engine instructions for these units are contained in a separate manual. Retain all manuals for future reference. 2. Never use this generator for any application other than that specified by the manufacturer. Never operate this generator under conditions not approved by the manufacturer. Never attempt to modify this generator to perform in any manner not intended by the manufacturer. 3. For maintenance and repairs, use only products and parts recommended by the manufacturer. 4. Be sure that the generator is operated only by persons who have read and understand these instructions. 5. Keep all persons away from the generator during operation. Fig. 1 Assembled Unit GN3560V 6. Keep the generator clean and well maintained at all times. Shut off the generator engine and disconnect the spark plug wire before performing any service or maintenance to the unit. 8. Use only unleaded fuel. Do not refill the fuel tank while the engine is running. Use precautions to prevent fuel spillage during refills. Be sure the fuel tank cap is securely in place before starting the engine. Allow engine to cool for at least two minutes before refueling. Never mix oil with gasoline for this engine. Oil is used for engine lubrication purposes only. Fig. 2 Assembled Unit GN2560V Assembly NO TOOLS REQUIRED FOR ASSEMBLY Fig. 3 Handle Assembly IN216502AV 5/98 Operating Instructions GN2560V, GN2563V, GN3560V and GN3565V Operation PRE-OPERATION 1. Check engine oil level everytime you start your generator. Refer to the Engine Manual for SAE, API and fill quantity specifications. 2. Use of a Ground Fault Circuit Interrupter (GFCI) is strongly recommended. Ground Fault Circuit Interrupters can significantly reduce the possibility of injury if an electrical short occurs. ALWAYS OPERATE YOUR GENERATOR UNDER THESE NEVER OPERATE YOUR GENERATOR UNDER THESE CONDITIONS: CONDITIONS: 1. Read and understand these instructions 1. Rain or inclement weather 2. Excessive vibration 2. Clear of all persons 3. Sparking 3. Properly grounded (generator) 4. Engine misfire 4. Properly grounded (tools, 5. Electric output loss appliances, etc.) 6. Change or fluctuating engine 5. Flat level surfaces speed 6. Well ventilated areas 7. Overheating in connected equipment 8. Damaged receptacles 9. Damaged, broken or missing parts 10. Guarding components removed A Ground Fault Circuit Interrupter may not be effective if used on a generator that is not grounded! 3. When installing a GFCI, be sure to follow all national and local regulations, or call a licensed or certified electrical technician. STARTING 1. Check oil level and fuel. 2. Remove all electrical loads from the generator. 3. Set the switch to the ON position. 4. Move the choke/run switch to the choke position. 5. Pull the starter rope with a brisk smooth motion. 6. Move the choke/run switch to the run position. 7. After each start up, allow engine to run 2-3 minutes with no load. Engine speed is preset to provide proper output voltage. Never attempt to modify or adjust engine speed or output voltage. GENERATOR SHUT OFF 1. Remove all electrical load devices from the generator. 2. Allow the engine to run for 2-3 minutes with no electrical loads. 3. Set the switch to the OFF position. This will stall the engine. 4. Verify that the generator has completely stop...
Эта инструкция также подходит к моделям:Электрогенераторы - GN2563V (287.86 kb)
Электрогенераторы - GN3560V (287.86 kb)
Электрогенераторы - GN3565V (287.86 kb)