Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
1. Check that the sensor cable is connected to J4 on the PCA printed circuit assembly. 2. Check the cable connection to the temperature sensor. 3. Replace sensor and/or cable -call AMEREC's Service Department. Control "ON". K60 Control displays "E002". Temperature sensor. or cable shorted. 1. Check sensor cable for damage from nail/staple puncture. 2. Check sensor cable ends for frayed/exposed wire strands. 3. Replace sensor and/or cable -call AMEREC's Service Department. Control "ON". K60 Control displays ">>>.". Steambath temperature over 132 .. or Sensor/cable is faulty. 1. If bath is too hot, shut off circuit breaker and call AMEREC's Service Department. 2. Treat as "E002" fault above. Control won't turn "OFF". (Control light on). Control is faulty. 1. Replace the control -call AMEREC's Service Department. Control "ON". (Control light on) Unit won't steam. Note: Time/Temp properly. displayed on K60. Unit has not filled completely. or Generator is faulty. 1. Wait at least 10 minutes after turning on the control. 2. Call AMEREC's Service Department. Unable to adjust Time or Temp setting with K60. Control is faulty. or Generator is faulty. 1. Replace control -call AMEREC's Service Department. 2. Replace PCA -call AMEREC's Service Department. Sudden increases in rate water sputters out of steam head. Foaming contaminants in the water supply. 1. Flush tank 3 times. See Section 4. 4209-24 12/09/02 4209-24 12-09-02 AK Series w/K60 Control Owners Manual page 4 1 28 12 4 43 29 15 24 23 2 16 7 8 22 19 5 18 17 20 14 6 13 3 39 33 44 21 34 9 36 35 11 P.O. Box 2258, Woodinville WA 98072 425-951-1120 Fax: 425-951-1130 email address: amerec @ amerec .com ...
Эта инструкция также подходит к моделям:Электрогенераторы - AK10 (202.82 kb)
Электрогенераторы - AK10 (202.82 kb)
Электрогенераторы - AK5 (202.82 kb)
Электрогенераторы - AK10 (202.82 kb)