Войти:
Оценок - 0, средний балл: 0 ( )

Инструкция по эксплуатации Philips, модель HP6368/00

Производитель: Philips
Размер: 1.05 mb
Название файла:
Язык инструкции:itentresfrdenlptdafi
Перейти к скачиванию



Фрагмент инструкции


general -The appliance complies with the internationally approved IEC safety regulations and can be safely used in the bath or shower and cleaned under the tap (Fig. 2). Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the EnglisH instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Preparing for use charging It takes approximately 10 hours to charge the batteries fully. When the batteries are fully charged, the appliance has a cordless shaving time of up to 40 minutes. Always switch off the appliance before you connect it to the mains. 1 Insert the appliance plug into the appliance (1). Plug the adapter into a wall socket (2) (Fig. 3). The charging light on the adapter goes on. , Note:The charging light on the adapter remains on after the appliance is fully charged. Note: Do not leave the adapter plugged in for longer than 14 hours, as this may affect the lifetime of the batteries. rechargeable batteries low or empty (HP6368 only) -If the batteries run low during use, the batter y low light lights up.You can continue to shave for a few minutes. (Fig. 4) -When the batteries are empty, the batter y-low light goes out and the appliance stops. Charge the batteries immediately. -When you switch off the appliance while the batteries are low, the batter y-low light flashes 4 times. attaching/detaching the shaving head 1 2 To attach the shaving head, slide it into the guiding grooves on bothsides of the opening in the handle.Then press the shaving head onto the appliance (‘click’) (Fig. 5). To detach the shaving head, pull it off the appliance (Fig. 6). EnglisH Caution: Do not exert excessive pressure on the double shaving foil to avoid damage. using the appliance Make sure that the appliance is fully charged before you use it for the first time. Note:You cannot use the Ladyshave while it is connected to the mains. shaving Note:When you use the appliance for shaving, you can use it under both dry and wet conditions. 1 Place the double shaving foil and the integrated trimmer gently on the skin. Stretch the skin with your free hand while you shave your bikini line. (Fig. 7) Note: Do not press the appliance too firmly onto the skin. Note:When you shave the underarms, raise your arm to stretch the skin. 2 Move the appliance slowly over the skin against the direction of hair growth. Make sure that the trimmer and the double shaving foil are always in full contact with the skin (Fig. 8). Note: If you move the appliance over the skin too fast, you may not obtain a smooth result. Tip:To achieve the best result when you shave wet, lather your skin with soap or shaving cream before you start to shave. Caution: Never apply any cream or foam before you start to shave under dry conditions. 10 EnglisH cleaning and maintenance Always switch off and unplug the appliance before you clean it. Never switch on the appliance while you clean it or while the cutting unit is not attached. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. cleaning the shaving head 1 2 Press the on/off button to switch off the appliance (Fig. 9). Pull the shaving head off the appliance (Fig. 6). Do not exert pressure on the double shaving foil to avoid damage. 3 4 Push the cutting unit release slide to the right (1) and remove the cutting unit (2) (Fig. 10). Clean the cutting unit and the inside of the shaving head with the cleaning brush. Also brush away any hairs that have collected under the trimmer (Fig. 11). Caution: Do not brush the foil to avoid damage to the brush or the foil. 5 6 You can also rinse the cutting unit and the shaving head under the tap.To dry the cutting unit and the shaving head, shake them firmly. (Fig. 12) Place the cutting unit back onto the shaving head (‘click’) (Fig. 13). Note: Make sure that the shaving head and the cutting unit are completely dry before you reattach them onto the appliance. maintenance 1 2 Lubricate the cutting unit (double shaving foil and trimmer) with a drop of sewing machine oil twice a year (Fig. 14). Let the appliance operate briefly to spread the oil. EnglisH 11 replacement The shaving head and the adapter of the appliance can be replaced. If you need to replace one or more par ts, go to your Philips dealer or an authorised Philips ser vice centre. If you use the Ladyshave two or more times a week, we advise you to replace the shaving head after one or two years or if it is damaged. storage 1 Store the appliance in a safe, dry place. Environment -Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preser ve the environment (Fig. 15). -The built-in rechargeable batteries contains substances that may pollute the environment. Always remove the batter...

Эта инструкция также подходит к моделям:
Электробритвы - HP6366/00 (1.05 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории