Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Optimising the lifetime of the rechargeable
Cleaning
EnGlIsH
battery
Never use scouring pads, abrasive cleaning agents or
Introduction
When you have charged the appliance for the first time,
aggressive liquids such as alcohol, petrol or acetone to
Congratulations on your purchase and welcome to
we advise you to use it until the battery is completely
clean the appliance.
Philips! To fully benefit from the support that Philips offers, empty.
1 Make sure the appliance is switched off and
register your product at www.philips.com/welcome.
Do not recharge the appliance in between the trimming
sessions.
disconnected from the mains.
General description (Fig. 1)
Continue to use the appliance until the motor almost
2 Remove the beard trimming comb.
A Beard trimming comb
stops running during a session. Then recharge the battery.
3 Open the cutting unit (Fig. 10).
B Cutting unit
Follow this procedure at least twice a year.
C Precision Zoom Lock
4 Clean the cutting unit and the inside of the
` adjustment ring
Trimming
D Charging light
appliance with the cleaning brush supplied (Fig. 11).
E Socket for appliance plug
Always comb the beard and/or moustache with a fine
5 Push the cutting unit back onto the appliance to
F On/off slide
comb before you start trimming.
close it (‘click’) (Fig. 12).
G Adapter
When you trim for the first time, be careful. Do not
H Appliance plug
move the trimmer too fast. Make smooth and gentle
Note: The appliance does not need any lubrication.
I Cleaning brush
movements.
Replacement
Important
Trimming with beard trimming comb
Only replace a worn or damaged cutting unit with an
Read this user manual carefully before you use the
1 Turn the Precision Zoom Lock ` adjustment ring
original Philips cutting unit, available from authorised
appliance and save it for future reference.
to the desired setting. (Fig. 4)
Philips service centres.
Danger
See the table below for an overview of the settings and
1 Open the cutting unit.
- Make sure the adapter does not get wet.
the resulting hair lengths.
2 Pull the old cutting unit upwards to remove
Warning
Setting
Resulting hair length
it (Fig. 13).
- The adapter contains a transformer. Do not cut
3 Insert the two lugs of the new cutting unit into the
off the adapter to replace it with another plug, as
1
1mm
guiding slots (Fig. 14).
this causes a hazardous situation.
- This appliance is not intended for use by persons
2
2mm
4 Push the cutting unit back onto the appliance
(including children) with reduced physical, sensory
(‘click’) (Fig. 12).
or mental capabilities, or lack of experience and
3
3.5mm
Environment
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
4
5mm
- Do not throw away the appliance with the normal
person responsible for their safety.
household waste at the end of its life, but hand it in
- Children should be supervised to ensure that they
5
7mm
at an official collection point for recycling. By doing
do not play with the appliance.
this, you help to preserve the environment (Fig. 15).
6
9mm
- The built-in rechargeable battery contains substances
Caution
that may pollute the environment. Always remove
- Use, charge and store the appliance at a temperature
7
11.5mm
the battery before you discard and hand in the
between 5°C and 35°C.
appliance at an official collection point. Dispose of
- Only use the adapter supplied.
8
14.5mm
the battery at an official collection point for batteries.
- Never immerse the appliance in water or rinse it
If you have trouble removing the battery, you can
under the tap.
9
18mm
also take the appliance to a Philips service centre.
- If the adapter is damaged, always have it replaced
The staff of this centre will remove the battery for
with one of the original type in order to avoid a
you and will dispose of it in an environmentally safe
hazard.
The setting appears in the window below the Precision
way. (Fig. 16)
- This appliance is only intended for trimming the
Zoom Lock ` adjustment ring.
human beard. Do not use it for any other purpose.
Note: When you trim for the first time, start at the highest
Removing the rechargeable battery
- Do not use the appliance if the cutting unit or the
setting (9) to familiarise yourself with the appliance.
beard trimming comb is damaged or broken, as this
Only remove the rechargeable battery if it is completely
may cause injury.
2 Switch on the appliance.
empty.
Electromagnetic fields
3 To trim most effectively, move the trimmer against
1 Disconnect the appliance from the mains and let
This Philips appliance complies with all standards
the hair growth direction. Make sure the surface
the appliance run until the motor stops.
regarding electromagnetic fields (EMF). If handled
of the comb always stays in contact with the
2 Undo the screw in the housing of the
properly and according to the instructions in this user
skin (Fig. 5).
trimmer (Fig. 17).
manual, the appliance is safe to use based on scientific
4 If a lot of hair has accumulated in the beard
evidence available today.
trimming comb, remove the comb and blow and/or 3 Separate the 2 housing parts with a
screwdriver (Fig. 18).
General
shake the hair out of it. The selected setting does
- The appliance is equipped with an automatic voltage
not change when you do this (Fig. 6).
4 Cut the wires close to the battery holder with a
selector and is suitable for mains voltages from 100
Never pull at the flexible top of the beard trimming
pair of household scissors (Fig. 19).
to 240 volts.
comb. Always pull at the bottom part.
5 Remove the battery holder with the rechargeable
- The adapter transforms 100-240 volts to a safe low
battery (Fig. 20).
voltage of less than 24 volts.
Trimming at the unique ‘stubble look’ setting
1 To create a ‘stubble look’, trim with the beard
6 Use a screwdriver to pry the battery off the
Charging
trimming comb set to setting 1 (Fig. 7).
printed circuit board (Fig. 21).
Charge the appliance fully before you use it for the first
Do not connect the appliance to the mains again after
time.
Trimming without beard trimming comb
you have opened it.
It takes approximately 10 hours to fully charge the
Use the trimmer without beard trimming comb to trim
appliance.
full beards and single hairs.
Guarantee & service
When it is fully charged, the appliance has a cordless
1 Pull the beard trimming comb off the
If you need service or information or if you have a
operating time of up to 35 minutes.
appliance (Fig. 8).
problem, please visit the Philips website at
Note: You can use the appliance cordless as well as
Never pull at the flexible top of the beard
www.philips.com or contact the Philips Consumer Care
connected to the mains.
trimming comb. Always pull at the bottom part.
Centre in your country (you find its phone number in
the worldwide guarantee leaflet). If there is no Consumer
1 Make sure the appliance is switched off (Fig. 2).
2 Switch on the appliance.
Care Centre in your country, go to your local Philips
2 Insert the appliance plug into the appliance (Fig. 3).
3 Make well-controlled movements. Touch the hair
dealer.
3 Put the adapter in the wall socket.
lightly with the trimmer (Fig. 9).
, The charging light on the appliance goes on to
Corded trimming
indicate that the appliance is charging.
If the battery is low, you can also use the appliance from
Note: The charging light does not change colour and does
the mains:
not go out when the appliance is fully charged.
1 Switch off the appliance, insert the adapter in the
4 After charging, remove the adapter from the
wall socket and wait a few seconds before you
wall socket and pull the appliance plug out of the
switch on the appliance.
appliance.
Note: If the battery is completely empty, wait a few minutes
before you switch on the appliance.
2
4222.002.8032.3
...Эта инструкция также подходит к моделям:
Электробритвы - QT4021 (4.95 mb)