Оценок - 2, средний балл: 4 ( )

Производитель: Bosch Размер: 926.63 kb Название файла: Язык инструкции:

A “beep” will be heard. Then press either the plus (+) or minus (-) button, to the right of the display, to set the correct time. If the plus (+) or minus (-) button is pressed it will advance or decrease the time in 1 minute increments, if the plus (+) or minus (-) button is held in the minutes will increase or decrease in 10 minute increments. Once the time is properly set depress the Set Clock button again to enter the time. A “beep” will sound and the Set Clock symbol, in the upper right, will disappear. To change the time of day simply repeat the steps described above. To check the time of day when the timer is in use depress the Set Clock button. The time of day will be displayed briefly and then will return to the timer function. Timer The timer acts as a kitchen timer, counting down from the set time. To Set Timer • Press Timer button. A “beep” will be heard and the display will change from showing the time of day to read zero (.00) and say SET TIMER, to the right, as shown in Figure 6. • Then press either the plus (+) or minus (-) button, to the right of the display, to set the timer to the time interval desired. Notes: 1. Each time the plus (+) or minus (-) button is depressed the display will increase or decrease in 1 minute increments. If the plus (+) or minus (-) button is held in the display will increase or decrease in 10 minute increments. 2. If the plus (+) or minus (-) button is not depressed within 5 seconds of depressing the Timer button the Timer button will have to be depressed again to again call up the timer mode. • Once the desired time interval is set release the buttons. • The timing interval will start after approximately 4 seconds. 9 • The indicator word TIMER will remain in the display during timer countdown. • The timer will countdown in minutes until the last minute when it will switch over and countdown in seconds. • At the end of the timing interval the indicator word TIMER will blink on and off and three “beeps” will be heard. • The display will return to time of day or any active programmed function and “beeping” will continue every 10 seconds until any button is touched. • Once any button is touched the flashing word TIMER disappears from the display. To Cancel Timer With the indicator word TIMER in the display all that is necessary to cancel the timer is to depress the Timer button once. If some other timed function has been programmed after setting the timer, the TIMER indicator word can be recalled to the display by depressing the Timer button. Then with the indicator word TIMER in the display you can, as above, cancel the timer by depressing the Timer button a second time. Then after 5 seconds the display will return to time of day or any active programmed function. To Check Timer During Timed Function If some other timed function has been programmed after setting the timer, TIMER may be recalled to the display by depressing the Timer button. The amount of time remaining on the timer can then be viewed. 10 Using the Oven Controls Figure 7. Double Oven Control Panel, HBL/HBN45.. The oven controls may be used to operate the oven manually or under control of the oven programmer. Manual operation will be discussed first and then use of the oven programmer. Manual Operation of the Oven Before turning on your oven, position the racks properly for their intended use. To change the position of the racks, lift rack at the front and pull-out and re-insert at the desired level. For manual operation of the oven set the Timer/Manual Selector knob (see Figure 3) to Manual. If you have a double oven, as shown above (Figure 7) you have three setting positions available: • Timer Upper Oven - when on this setting the programmer must be used to control the upper oven while the lower oven may be operated manually • Both Manual - when on this setting both ovens may be used manually. • Timer Lower Oven - when on this setting the programmer must be used to control the lower oven while the upper oven may be operated manually. Once you have set the mode selector to Manual or, if you have a double oven, decided which oven you are going to use: 1. Set Mode selector knob for the oven to the cooking mode desired. Refer to Figure 3 and Table 3 if you are not sure which of the knobs on your oven is the selector knob or which function you wish the oven to perform. Note: The cooling fan will begin to run as soon as the function selector knob is turned from the Off position. 2. Set the temperature control knob for the oven to the temperature desired. Note: If you have a convection oven and have selected THAW it is not necessary to set the temperature control knob as no heating takes place in THAW mode. 3. Once cooking has been completed be sure to turn the selector knob and the temperature knob to the Off position. 11 Electronic Control of Oven Immediate Start /Automatic Shut-Off To use the electronic control so that your cooking starts immediately an...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: