Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
! ! DANGER:This symbolwarns of imminenthazardwhichwill result in serious injury or death. ! ! ! CAUTION:This symbol refers to a potential hazard or unsafe practice, whichmay result in minor or moderateinjury or product or propertydamage. ! ! NOTICE: This symbol refers to information that needs special attention or must be fully understood even though not dangerous. SAFETY PRECAUTIONS Before installing and operating this equipment be sure everyone involved in its operation are fully trained and are aware of all precautions.Accidents and problems can result by a failure to follow fundamental rules and precautions. The following words and symbols, found in this manual, alert you to hazards to the operator, service personnel or the equipment.The words are defined as follows: SPECIFICATIONS (All 208 or 240 Volts, 50-60 Hz, Single Phase) Model Model Input Power Requirement Input Power Requirement Heating Elements Heating Elements Electrical Electrical CMC-24 (Counter Top) 2.4kw 2 @ 1200W CMW-24 (Wall Mount) 2.4kw 2 @ 1200W CMP-24 (Pass Thru) 2.4kw 2 @ 1200W CMC-36 (Counter Top) 3.6kw 2 @ 1800W CMW-36 (Wall Mount) 3.6kw 2 @ 1800W CMP-36 (Pass Thru) 3.6kw 2 @ 1800W CMC-48 (Counter Top) 4.2kw 2 @ 1050W CMW-48 (Wall Mount) 4.2kw 2 @ 1050W CMP-48 (Pass Thru) 4.2kw 2 @ 1050W CMC-48C (Counter Top) 3.4kw 2 @ 850W CMW-48C (Wall Mount) 3.4kw 2 @ 850W CMP-48C (Pass Thru) 3.4kw 2 @ 850W IMMEDIATELYINSPECTFORSHIPPINGDAMAGE All containers should be examined for damage before and during unloading. The freight carrier has assumed responsibility for its safe transit and delivery. If equipment is received damaged, either apparent or concealed, a claim must be made with the delivering carrier. A. Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then be signed by the carrier representative (Driver). If this is not done, the carrier may refuse the claim.The carrier can supply the necessary forms. B. For concealed damage or loss, if not apparent until after equipment is uncrated, a request for inspection must be made to the carrier within 15 days The carrier should arrange an inspection.Be certain to hold all contents and packaging material. Installation and start up should be performed by a qualified installer who thoroughly read, understands and follows these instructions. If you have any questions concerning the installation, operation, maintenance or service of this product, write Technical Service Department APW Wyott Foodservice Equipment Company, P.O. Box 1829, Cheyenne,WY82003. ! ! CAUTION: When installed the plug for this unit should be accessible. If the power cord is damaged,replace only with an identical power cord. ! WARNING:Check the data plate on this unit before installation. Connect the unit only to the voltage and frequency listed ! on the data plate.Connectonly to 1 or 3 phase as listed on the data plate. 5 CMC-24 27 17 . 19 CMW-24 27 17 . 15 CMP-24 27 16 19 . . . CMC-36 36 . 17 . 19 . CMW-36 36 . 17 . 15 . CMP-36...
Эта инструкция также подходит к моделям:Электрические печи - CMC-48 (275.64 kb)
Электрические печи - CMP-36 (275.64 kb)
Электрические печи - CMP-48 (275.64 kb)
Электрические печи - CMW-36 (275.64 kb)