Оценок - 3, средний балл: 3
(
)
)
|
Фрагмент инструкции
In case of shipping damage, DO NOT use. Contact Carrier/Dealer for further instruction. SAFETY SUMMARY To ensure the safe installation of the Bolt-In-Place/Spring Button Front Rigging Kit, these instructions MUST be followed: WARNING DO NOT install or use this equipment without first reading and understanding these instructions and the Owner’s Manual supplied with the wheelchair. If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel before attempting to install this equipment - otherwise, injury or damage may occur. INSTALLATION WARNING After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur. Bolt-In-Place Front Rigging Kit 1110266 contains the following items: DESCRIPTION QUANTITY Riv Nut 2 Button Head Screw 2 1/8-inch Hex key 1 Spring Buton Front Rigging kit 1112127 contains the following items: DESCRIPTION QUANTITY Spring buttons 4 INSTALLING THE BOLT-IN-PLACE FOOTPLATE KIT (FIGURE 1) NOTE: This kit mounts the footplate assembly to the front rigging support so that tools are required to remove or adjust the footrest assembly. 1. Remove the front rigging from the wheelchair. Refer to the wheelchair owner’s manual shipped with wheelchair. 2. Pull up on the cam lock lever to unlock the cam. NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each set will be visible one at a time allowing finer footplate height adjustment. 3. Push IN and hold the release button as shown in DETAIL “A” of FIGURE 1. 4. Rotate the lower footplate assembly 1/4 turn. Part No. 1114831 1 Bolt-In-Place/Spring Button Front Rigging Kit 5. Remove the lower footplate assembly from the front rigging support. 6. Squeeze and push the release button down to remove from the footplate tube. 7. Ensure the cam lock lever is UP and unlocked. 8. Insert the footplate tube into the front rigging support. 9. Position the lower footplate assembly to the desired height. 10. Align the adjustment holes in the front rigging support and footplate assembly. 11. From the outside of the swingaway front rigging, insert the riv nut through both the front rigging support and the footplate assembly. 12. From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the riv nut. 13. Using a screwdriver to hold the riv nut in position, securely tighten the button head screw. Torque to 32 in-lbs. 14. Push the cam lock lever DOWN to the locked position. 15. Reinstall the swingaway front rigging assembly. Refer to the owner’s manual that shipped with wheelchair. 16. Repeat this procedure for the other footplate, if necessary. Riv Nut Front Rigging Support DETAIL "A" NOTE: Swingaway footrest shown. Front Rigging Support Footplate AssemblyCam Lock Lever Release ButtonAdjustment Holes Front Rigging Support INSIDE OF Footplate Assembly SWINGAWAY FRONT NOTE: Swingaway RIGGING footrests shown. OUTSIDE ...
Эта инструкция также подходит к моделям:Инвалидные коляски - 1114831 (207.27 kb)
Инвалидные коляски - 1121271 (207.27 kb)