Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
OUTSIDE OF SWINGAWAY FRONT RIGGING Cam Lock Lever Button Head Screw Footplate Assembly Adjustment Hole FIGURE 1 - INSTALLING THE BOLT-IN-PLACE FRONT RIGGING KIT Bolt-In-Place/Spring Button 2 Part No. 1114831 Front Rigging Kit BOLT-IN-PLACE HEIGHT ADJUSTMENT (FIGURE 1) NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest. 1. Remove the swingaway front rigging. Refer to INSTALLING/REMOVING THE FRONT RIGGINGS in the owner’s manual shipped with wheelchair. NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure. 2. Pull the cam lock lever UP to UNLOCKED position. 3. Using a screw driver to hold the riv nut in position, remove the button head screw from the riv nut. 4. Remove the riv nut and button head screw securing the footplate assembly to the front rigging support. 5. Adjust the footplate assembly height by aligning the desired adjustment holes in the upper front rigging support and footplate assembly. 6. From the outside of the swingaway front rigging, insert the riv nut through both the front rigging support and the footplate assembly. 7. From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the riv nut. 8. Using a screwdriver to hold the riv nut in position, securely tighten the button head screw. Torque to 32 in-lbs. 9. Rotate cam lock lever DOWN to LOCKED position. 10. Repeat STEPS 1-9 to adjust the remaining footrest. 11. Reinstall the swingaway front rigging. Refer to INSTALLING/REMOVING THE FRONT RIGGINGS in the owner’s manual shat shipped with wheelchair. Part No. 1114831 3 Bolt-In-Place/Spring Button Front Rigging Kit INSTALLING THE SPRING BUTTON FRONT RIGGING KIT (FIGURE 2) NOTE: This kit allows tool-less removal or adjustment of the footplate assembly. 1. Remove the front rigging from the wheelchair. Refer to the wheelchair owner’s manual shipped with wheelchair. \ 2. Pull the cam lock lever UP to UNLOCKED position. 3. Using a screw driver to hold the riv nut in position, remove the button head screw from the riv nut as shown in DETAIL “A” of FIGURE 2. 4. Remove the riv nut and button head screw securing the footplate assembly to the front rigging support. 5. Remove the footplate assembly from the upper front rigging support. 6. Perform one of the following as shown in DETAIL “B” OF FIGURE 2: A. FOOTRESTS: • With the spring pointing UP, insert the spring button into the footplate tube so that the release buttons FULLY protrude through the top set of mounting holes. B. ELEVATING LEGRESTS AND FOOTRESTS WITH ADJUSTABLE ANGLE FOOTPLATES: • With the spring pointing DOWN, insert the bottom spring button into the footplate tube so that the release buttons FULLY protrude through the bottom set of mounting holes. • With the spring pointing UP, insert the top spring button into the footplate tube so that the release buttons FULLY protrude through the top set of mounting holes. NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each set wil...
Эта инструкция также подходит к моделям:Инвалидные коляски - 1110266 (207.27 kb)
Инвалидные коляски - 1121271 (207.27 kb)