Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
For outdoor side burners using a 20 lb LP gas fuel tank: Slowly open the tank valve. NOTE: If flow limiting device activates, your side burner may not light. If your side burner does light, the flames will be low and will not heat properly. Turn 20 lb LP gas fuel tank valve and all control knobs off and wait 30 seconds. After shutting off the 20 lb LP gas fuel tank, very slowly open tank valve and wait 5 seconds before lighting. 2. For outdoor side burners using gas supply source other than 20 lb LP gas fuel tank: Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. Lighting Your Side Burner WARNING Burn Hazard Do not let the burner flame extend beyond the edge of the pan. Doing so can result in burns. WARNING Food Poisoning Hazard Do not let food sit for more than one hour before or after cooking. Doing so can result in food poisoning or sickness. 1. Remove the side burner cover. Do not light burners with the cover on. 2. Do not lean over the side burner. 3. Push in and turn the control knob to LITE/HI and hold in. 4. You will see the igniter glow. When burner is lit, release the knob. Turn knob to desired setting. 5. Repeat for the other burner as needed. IMPORTANT: If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before relighting. Manually lighting the side burner 1. Remove the outdoor side burner cover. 5. Do not lean over the side burner. Push in and turn the burner knob to LITE/HI for the burner closest to the lit match. The 2. Remove the manual lighting extension (see following burner will light immediately. When burner is lit, turn knob to illustration) and attach a match to the split ring. desired setting. 3. Strike the match to light it. 4. Guide the match to the burner you wish to light. 6. Repeat for each of the other burners as needed. 7. Remove match and replace manual lighting extension inside its holder. IMPORTANT: If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before relighting. If any burners do not light after attempting to manually light them, contact the KitchenAid Customer eXperience Center. See the “Assistance or Service” section. OUTDOOR SIDE BURNER CARE General Cleaning IMPORTANT: Before cleaning, make sure all controls are off and the side burner is cool. Always follow label instructions on cleaning products. For routine cleaning, wash with soap and water using a soft cloth or sponge. Rinse with clean water and dry at once with a soft, lint-free cloth to avoid spots and streaks. Do not use steel wool to clean the side burner, as it will scratch the surface. To avoid weather damage to finish, use stainless steel side burner cover. STAINLESS STEEL IMPORTANT: To avoid damage to stainless steel surfaces, do not use soap-filled scouring pads, abrasive cleaners, Cooktop Polishing Creme, steel wool, gritty wash cloths or paper towels. To avoid damage to the finish, cleaners should not contain chlorine. Food spills should be cleaned as soon as entire side burner is cool. Spills may cause permanent discoloration. Cleaning Method: ¦ Rub in direction of grain to avoid scratching or damaging the surface. ¦ KitchenAid® Stainless Steel Cleaner and Polish Part Number 4396920 (not included) or KitchenAid® Stainless Steel Wipes Part Number 8212510 (not included): See “Assistance or Service” section to order. ¦ Liquid detergent or all-purpose cleaner: ¦ Rinse with clean water and dry with soft, lint-free cloth. ¦ Vinegar to remove hard water spots. ¦ Glass cleaner to remove fingerprints. EXTERIOR The quality of this material resists most stains and pitting, providing that the surface is kept clean, polished and covered. ¦ Apply stainless steel polish to all non-cooking areas before first use. Reapply after each cleaning to avoid permanent damage to surface. ¦ Cleaning should always be followed by rinsing with clean warm water. ¦ Wipe the surface completely dry with a soft cloth. ¦ For tough spots or baked-on grease, use Kitchen and BBQ Grill Degreaser Part Number 31617, a commercial degreaser designed for stainless steel. See “Assistance or Service” section to order. INTERIOR Discoloration of stainless steel on these parts is to be expected, due to intense heat from the burners. Always rub in the direction of the grain. Cleaning should always be followed by rinsing with clean, warm water. Cleaning Method: ¦ Liquid detergent or all-purpose cleaner. ¦ Rinse with clean water and dry completely with a soft, lint- free cloth. ¦ A heavy-duty scrub sponge can be used with mild cleaning products. ¦ For small, difficult-to-clean areas, use Kitchen and BBQ Grill Degreaser Part Number 31617, a commercial degreaser designed for stainless steel. See “Assistance or Service” section to order. SIDE BURNER CAPS AND GRATE Cleaning Method: ¦ Clean with a brass bristle brush. ¦ Wash grate using mild detergent, warm water and degreaser. ¦ Rinse with clean water and dry with soft, lin...
Эта инструкция также подходит к моделям:Газовые горелки - KBZU242VSS (982.06 kb)
Газовые горелки - KBZU122VSS (982.06 kb)