17 FUSE BOARD ................................................................................................................................................. 17 RELAY BOARD .............................................................................................................................................. 17 WIRING DIAGRAM ......................................................................................................................................... 17 HYDRAULIC DIAGRAM .....

22 FUSE CHECK/REPLACEMENT/RESET....................................................................................................................................... 23 TROUBLESHOOTING ................................................................................................................................................... 24 SCRAPPING .........................................................................................................................................................

Do not lower the blades too much to where they fold over excessively and cause unneeded blade wear. FIGURE 5 A-16 - 56041647 - Adhancer™ R28-C, R32-C / BR 800S TRIO EDS™ revised 2/07 ENGLISH / A-17 GENERAL MACHINE TROUBLESHOOTING Problem Possible Cause Remedy Poor water pick-up Worn or torn squeegee blades Reverse or replace Squeegee out of adjustment Adjust so blades touch floor evenly across entire width Recovery tank full Empty recovery tank Recovery tank drain hose leak Secu

Raise the squeegee tool off the floor, then unsnap the Center Latch (A) on the squeegee tool. 2 Remove the Tension Straps (B). 3 Slip the rear blade off the alignment pins. 4 The squeegee blade has 4 working edges. Turn the blade so a clean, undamaged edge points toward the front of the machine. Replace the blade if all 4 edges are nicked, torn or worn to a large radius. 5 Install the blade, following the steps in reverse order and adjust the squeegee tilt. To Reverse or Replace the Front S

Sulfuric acid in batteries can cause severe injury if allowed to contact the skin or eyes. Explosive hydrogen gas is vented from inside the batteries through openings in the battery caps. This gas can be ignited by any electrical arc, spark or flame. When Servicing Batteries... • Remove all jewelry. • Do not smoke. • Wear safety glasses, a rubber apron and rubber gloves. • Work in a well-ventilated area. • Do not allow tools to touch more than one battery terminal at a time. • ALWAYS disc