Оценок - 5, средний балл: 4
(
)
)
|
Фрагмент инструкции
When mowing embankments and slopes, special care is to be taken: v make sure you always have a safety distance and wear shoes with a non slip sole. 3. Assembly Always cut diagonally to the slope. Take special care when moving backwards and when pulling the lawn mower. Danger of stumbling! If the cutting tools or the lawnmower should run into an obstruction and/or solid objects, the lawn mower should be properly and thoroughly inspected. v Only work when visibility is good. Never leave the lawnmower unattended. If your work is interrupted, store the mower in a safe place. GB 4. Operation 3421 1. Squeeze lower part of upright 1 together gently until it snaps into the pins b. 2. Push U-shaped retaining washer zon to the groove S on the bolt b. 3. Screw middle parts of upright 2 firmly to lower part of upright 1 with 2 wing nuts 3. 4. Screw upper part of upright 4 to middle parts of upright 2 with 2 wing nuts 3. 1b zS Mowing correctly: To produce a well-maintained lawn we recommend cutting the lawn regularly one a week if possible. The lawn becomes thicker if cut frequently. Relatively long cut grass (> 1 cm) must be removed so that the lawn does not become yellow and matted. After relatively long intervals between mowing (holiday lawn), first of all cut in one direction with the cutting height as high as possible (42 mm), then cut in the crosswise direction at the cutting height required. The blades of grass may not be more than 12 cm long if they are to be cut with a cylinder mower. If possible, only cut the grass when it is dry, if the grass is damp, the cutting pattern will be uneven. 9 GB Adjusting the cutting height: 566 The cutting height can be set to any position between 12 mm and 42 mm. 1. Stand behind the cylinder mower with one foot on the roller 5. 2. Release the two locking screws 6 and adjust to the correct height in the inspection window 7. 7 3. Tighten the two locking screws 6 on both sides to the same height. The locking screws 6 must always be set to the same height on both sides. The mower may only be adjusted to a depth in which the lower blade does not touch the ground when it is uneven. 5. Putting into Storage Storage: v Clean cylinder mower before storage (see 5. Maintenance) and store in a dry place. The cylinder mower can be collapsed to save space by releasing the wing nuts on the upright. 6. Maintenance Cleaning the mower: DANGER! Cutting mechanism can cause injuries! V Wear suitable work gloves when undertaking maintenance. Always keep the cylinder mower clean and remove grass deposits. Deposits affect the cutting result as well as discharge of grass clippings. Residual dirt and grass is easily removed immediately after mowing. 1. Remove grass deposits with a brush and a cloth. 2. Oil the red cutting mechanism lightly with thin oil (e.g. sprayed oil). 7. Troubleshooting DANGER! Cutting tool can cause injuries! V Wear suitable work gloves when rectifying faults. 10 Fault Possible Cause Rectification Abnormal Noises Screws ...
Эта инструкция также подходит к моделям:Газонокосилки - 380 (114.36 kb)
Газонокосилки - 300 (114.36 kb)
Газонокосилки - 300 (114.36 kb)
Газонокосилки - 300 (114.36 kb)