Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
v Adjust cutting mechanism. Blade blunt. v Regrind or replace blade. Grass too long (e.g. after a v Cut lawn shorter with a relatively long absence). sickle. GB Adjusting the cutting mechanism: 980A 9B0 The cutting gear of your lawn mower was optimally adjusted before leaving our company. If, after longer use, a clean cut of the grass is no longer possible or the blade roller contacts the lower blade, then the lower blade should be adjusted as follows: 1. Unhook upright and clean cylinder mower. 2. Check cylinder 9 and lower blade 0 for notches and remove these with a grindstone if necessary. 3. Unscrew internal hexagon screws A with an internal hexagon wrench (5 mm) anticlockwise until the cylinder 0 turns freely. 4. Push the feeler gauge supplied (thin strip of metal) 8 between one blade 9 on the cylinder and the lower blade 0. 5. Tighten left internal hexagon screw A with an internal hexagon wrench (5 mm) until the feeler gauge 8 is held gently. 6. Continue turning the cylinder until the blade 9, already adjusted on the left side, is exactly above the lower blade 0 on the right side. 7. Tighten the right internal hexagon screw A with an internal hexagon wrench (5 mm) until the feeler gauge 8 is held gently. 8. Rotate cylinder 9. If a banging noise is produced during this, open up the internal hexagon screw A slightly on the side affected. When the cylinder and the lower blade can hardly be heard touching each other, the cutting mechanism has been adjusted correctly. 9. Cutting test: Place a strip of paper B in such a way on the lower blade 0 that it points towards the spindle of the cylinder 9. 10. Turn cylinder 9 carefully. If the lower blade is set correctly 0 the paper will be cut off as if with scissors. 11. Repeat the cutting test on the other blades 9. 11 GB Regrinding/repairs: 8. Accessories A A On safety grounds, only original GARDENA spares may be used. Please contact GARDENA Service if it is necessary to replace the cutting tool, which will only become blunt after several years use if well-maintained. Repairs to the cylinder mower and the installation of the blades can be undertaken by suitable specia list workshops. Have the cylinder mower checked over in the autumn if possible so that it is ready for use immediately when the next lawn-mowing season starts. If you have any problem with your cylinder mower, please contact our Customer Service. GARDENA Grass collecting bag Saves raking up the cut grass. Art. No. 4029 9. Technical Data Cutting width / Cutting height Cutting height adjustment Weight 300 (Art. No. 4020) 30 cm / 12 – 42 mm infinitely variable 8.0 kg 380 (Art. No. 4023) 38 cm / 12 – 42 mm infinitely variable 8.5 kg 10. Warranty GARDENA guarantees this product for 2 years (starting from the date of purchase). This guarantee covers all serious defects of the unit that can be proved to be material or manufacturing faults. Under warranty we will either replace the unit or repair it free of charge if the following conditions ap...
Эта инструкция также подходит к моделям:Газонокосилки - 380 (114.36 kb)
Газонокосилки - 300 (114.36 kb)
Газонокосилки - 300 (114.36 kb)
Газонокосилки - 300 (114.36 kb)