Оценок - 5, средний балл: 3.2 ( )

Производитель: Electrolux Размер: 817.47 kb Название файла: Язык инструкции:

3. Ask your local Service Centre to clean the air filter thoroughly and carry out any service or repairs required. 4. Drain engine of oil and petrol. Storing your Lawnmower 1. Do not store your lawnmower immediately after use. 2. Wait until the engine has cooled to avoid a potential fire hazard. 3. Clean your lawnmower 4. Store in a cool, dry place where your lawnmower is protected from damage. FAULT FINDING Engine Will Not Start 1. Ensure OPC Lever is in the start position. 2. Check that the control lever is in the Fast (run) position 3. Check that there is sufficient fuel in the tank and the cap air vent is clear. 4. Remove and dry the spark plug. 5. Petrol may be stale, replace. Once petrol has been replaced it may take a little time for fresh petrol to filter through. 6. Check that the blade bolt is tight. A loose bolt could cause difficult starting. 7. If the engine will still not start, immediately disconnect the spark plug lead. CONSULT YOUR LOCAL APPROVED SERVICE CENTRE. Engine Will Not Turn Over (Electrostart only) 1. Ensure OPC Lever is in the start position. 2. Battery flat - start your lawnmower manually. 3. If the engine will still not turn over, immediately disconnect the spark plug lead. CONSULT YOUR LOCAL APPROVED SERVICE CENTRE. Lack of Engine Power and/or Overheating 1. Check that the control lever is in the Fast (run) position. 8. After charging, disconnect the charger from the socket and charging point. 9. Replace the cap on the charging point. 10.The unit is now ready for use. Battery Replacement 1. The battery is located underneath a cover behind the engine (Z1). 2. Stop the lawnmower and disconnect the spark plug. 3. Remove the screws from the cover (Z2). 4. Remove cover (Z3) to gain access to the battery. Engine Maintenance Schedule Follow the hourly or calendar intervals, whichever occur first. More frequent service is required when operating in adverse conditions First 5 hours - Change oil. Every 5 hours or daily - Check oil level. Clean finger guard. Clean around silencer. Every 25 hours or every season - Change oil if operating under heavy load or high ambient temperature. Service air cleaner. Every 50 hours or every season - Change oil. Inspect spark arrester, if equipped. Every 100 hours or every season - Clean cooling system*. Replace spark plug. * Clean more often under dusty conditions, or when airborne debris is present or after prolonged operation cutting tall, dry grass. 2. Disconnect the spark plug lead and allow the engine to cool down. 3. Clean grass clippings and debris from around the engine and air inlets and the underside of the deck including the chute and the fan. 4. Clean the engine air filter (Ask your local Approved Service Centre to clean the engine air filter thoroughly). 5. Petrol may be stale, replace. Once petrol has been replaced it may take a little time for fresh petrol to filter through. 6. If the engine still lacks power and/or is overheating, immediately disconnect the spark plug lead. CONSULT YOUR LOCAL APPROVED SERVICE CENTRE. Excessive Vibration 1. Disconnect the spark plug lead. 2. Check that the blade is correctly fitted see page 6. 3. If the blade is damaged or worn replace it with a new one. 4. If vibration persists, immediately disconnect the spark plug lead. CONSULT YOUR LOCAL APPROVED SERVICE CENTRE. ENGLISH - 7 MAINTENANCE ENGINE SERVICING & GUARANTEE The engine fitted to your lawnmower is guaranteed by the Engine Manufacturer. To obtain further information contact yo...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: