|
Фрагмент инструкции
Order P/N: 00036800 - Three pack of 3 oz. cartridges or 00036700 - Ten pack of 14 oz. cartridges. Figure 9 OE0031 OE0192 16 Aliens« EZRider™ Orig. 1/98 Tire Pressure Battery Before each use, make a visual check of tires. The correct air pressure is 10-12 psi (65-83 kN/m2). Hydraulics and Transaxles HYDRAULIC FLUID WILL CAUSE SEVERE BURNS. Fluid in the hydraulic system can penetrate the skin and cause serious injury or death. Keep body and hands away from pin holes or nozzles which expel hydraulic fluid when under pressure. Use paper or cardboard and not hands to search for leaks. Make sure all hydraulic fluid connections are tight and all hydraulic hoses and lines are in good condition before applying pressure to the system. Foreign fluid injected into the skin must be surgically removed within a few hours by a doctor familiar with this form of injury or gangrene may result. Transaxle Fluid The transaxle fluid is a lifetime oil which need not be changed over the unit life. Sharpening Mower Blades I ferf A CAUTION MOVING PARTS AND SHARP BLADES can cut or amputate body parts. ALWAYS use sturdy gloves or padding to protect hands when working with mower blades. 1. Shut off the engine and unit. Remove the ignition key. Remove the ignition wire from the spark plug. 2. Remove the locknuts, flat washers, and blades from the spindle shafts. 3. Sharpen the beveled edges of the blades in a straight line. DO NOT change the angle of the beveled edge. If more than 0.5 inch (12.7 mm) are removed from the width of a blade, discard the used blade. Make sure the sharpened blades are balanced. Balance must be held within 1.3 in. oz. 4. Put the blades, washers, and locknuts back on the spindle shafts. 5. Tighten lock nuts to a torque of 60 ft. lbs. (82 Nm). 6. Put the ignition wire back on the spark plug. ELECTRIC SHOCK may result in injury and/or damage to unit. DO NOT allow objects to come into contact with both terminals at the same time. REVERSE CONNECTIONS may result in sparks which can cause serious injury. ALWAYS connect positive (+) lead of charger to positive (+) terminal, and negative (-) lead to negative (-) terminal. ALWAYS connect positive (+) cable FIRST, and negative (-) cable SECOND. EXPLOSIVE GASES from battery can cause death or serious injury. ALWAYS keep open flames, sparks, or smoking materials away from batteries. POISONOUS BATTERY FLUID contains sulfuric acid and its contact with skin, eyes, or clothing can cause severe chemical burns. ALWAYS wear safety glasses and protective gear near battery. DO NOT TIP any battery beyond a 45° angle in any direction. ALWAYS KEEP BATTERIES OUT OF REACH of children. Battery Electrolyte First Aid Follow First Aid directions for contact with battery fluid. • External Contact: Flush with water. • Eyes: Flush with water for at least 15 minutes and get medical attention immediately! • Internal Contact: Drink large quantities of water. Follow with Milk of Magnesia, beaten egg or vegetable oil. Get medical attention immediately! IMPORTANT: In case of internal contact, DO NOT induce vomiting. Ariens® EZRider™ Orig. 1/98 17 Battery Removal Remove battery from unit before servicing (Figure 10). To remove the battery from the unit: 1. Remove the four screws at the front of the seat support; use a 7/16” wrench. 2. Pull the control panel forward. 3. Remove wing nut from the Battery Rod and remove the rod. 4. Disconnect the negative (-) cable first. 5. Disconnect the positive (+) cable second. 6. Lift the battery out of the unit and place battery on a bench or other well ventilated area where an acid spill will not create damage. When service is finished, reinstall battery into unit and connect positive (+) cable first, then negative (-) cable. Electrolyte Level Every 25 hours or each week, check the electrolyte level of each cell by removing caps one at a time. The electrolyte level should be at level indicator. Use distilled water to fill each cell if needed. IMPORTANT: When distilled water is added to battery during freezing weather, it must be charged to mix water with electrolyte or water will remain at top and freeze. Battery Charger Under normal conditions the engine alternator will have no trouble keeping the battery charged. When unit has not been operated for an extended period of time and the battery has been completely discharged, a battery charger will be required for recharging. Before using a charger, an attempt can be made to recharge the battery using the engine alternator by jump starting the unit and allowing the engine to run. Charging FROZEN BATTERIES CAN EXPLODE and result in death or serious injury. DO NOT charge a frozen battery. Let the battery thaw out before putting on a charger. ALWAYS follow information provided on battery by battery manufacturer. Contact battery manufacturer for extensive instructions to charge battery. To charge: 1. Remove battery from unit per removal instructions abov...
Эта инструкция также подходит к моделям:Газонокосилки - 008-1540 (1.55 mb)
Газонокосилки - 009-1648 (1.55 mb)